PARQUET - Der Onlinekatalog

Quality Through and ThroughSolid wood floors have some major drawbacks. Humidity fluctuations can cause the wood to warp, uneven subfloorsrequire time-consuming sanding prior to installation, etc. In addition, a large amount of precious hardwood is neededto produce just a few square metres of flooring. Multilayer parquet from HARO easily solves these issues by using abalanced 3-layer construction. Here, the grain of the wood runs in different directons, which reduces the parquet’s3-layer construction with grains running in different directions reduces the natural swelling and shrinking of the wood byup to 70%. And compared to solid wood floors, multilayer parquet is also the better choice in terms of sustainability,eco-friendliness, and price-performance ratio.12343-layer constructionfor floating installation,full glue-down installation orinstallation with self-adhesiveComforTec system1. Approx. 3.5 mm (1/8’’) thick top layer of selected precious wood (with HARO PARQUET 3000approx. 2.5 mm (3/32’’)2. Solid spruce fingerstrips as middle layer (HDF E1 coreboard for the 3000 series)3. Softwood backing veneer4. Optional: Silent Pro luxury installation layer (approx. 2 mm (3/32’’) thick)/ with ComforTec: self-adhesiveundersideSurface finishWhether it’s the hard-wearing PERMADUR natural matt finish, the bioTec oil-waxfinish, or naturaLin plus, the “breathing” natural oil finish – we put the same care andattention into all our surface finishes. From the selection of the raw materials to theapplication of up to 7 coats required for the PERMADUR finish, we take care that theywill provide superior durability.12Precious wood wear layerThis is the top layer of a multilayer parquet floor. It consists of carefully selectedpremium wood that has been well seasoned and dried, and gently processed.Rely on our decades of experience in the production of parquet and enjoy the goodfeeling that you made the best choice.Middle layerThis layer consists of cross-glued solid spruce fingerstrips which ensure the lifelongstability of HARO PARQUET. Though invisible from the outside, this layer is verylabour and time-intensive to manufacture. We use only spruce of the same woodmoisture content and the same orientation of annual rings. This is essential toguarantee that your parquet will remain stable. The task of the middle layer is tobalance tensions in the top layer and thus guarantee maximum dimensional stability.3Bottom layerA backing veneer made of softwood further increases the floor’s stability.4InsulationInsulation underlays have a sound-absorbing effect and reduce strain on body jointsand spine. We offer underlays in different materials that are either factory-laminatedto the back of the board or available in loose rolls.112 | TECHNOLOGY | Construction