Electrolyser designs - Free Energy Info

A better solution is to use an electric engine for the vehicle. This can be an electric vehicle which wasdesigned from scratch as such, or it can be a standard vehicle which has been adapted for electric engineuse. These electric vehicles are usually limited in how far they can travel, but a good solution to this is to usean electrical generator to charge the batteries, both when the vehicle is in use and when it is parked. Thiselectrolyser can be used to run such a generator on water. With this arrangement, there are no CO2emissions and the vehicle is very environmentally friendly. The batteries provide the necessary suddenacceleration demands and the generator recharges the batteries during normal driving.Overview:Bob’s pulsed system has the following components:1. An electrical connection to the vehicle’s electrical system (with safety features built in).2. An “inverter” which raises the electrolyser voltage to 160 volts.3. Bob’s specially designed circuit board which generates a complicated water-splitting waveform.4. Bob’s specially designed toroidal transformer which links Bob’s circuit board to the electrolyser.5. Bob’s specially prepared 101-plate series-connected electrolyser.6. A dual-protection system for linking the electrolyser safely to the internal combustion engine.None of these items is particularly difficult to achieve, but each needs to be done carefully and exactly asdescribed, paying particular attention to the detailed instructions.Building the Case:The case needs to have very accurate slots cut in it. If you do not have a milling machine, then you shouldconsider getting a fabrication shop to mill the slots for you. The case has two ends, two sides, one base andone lid. Of these, the two sides and the base need 101 accurate grooves cut in them. The grooves are thereto hold the electrode plates securely in position, and have to be cut extremely accurately. The groove widthis set at 0.0003" less than the actual, measured plate thickness. This prevents any electrical flow around theplates. If you do not have the equipment to do this, then there is an enthusiast who is willing to do the cuttingfor people in the USA (and possibly elsewhere) at reasonable price. To contact him for pricing and deliverydetails, send an e-mail to eholdgate@tampabay.rr.com.Many people ask about moulding the slotted sides but this is physically impossible to do to the accuracyneeded and the cell performance depends on plate spacing to very high accuracy and slot width to evenhigher accuracy. This is not a backyard construction quality job and there are very, very few people with boththe equipment and skill to complete the construction to this degree of accuracy.10