Electrolyser designs - Free Energy Info

That water supply pipe is then housed in an outer pipe which has a hole drilled in it exactly above each of thebodies of electrolyte trapped between the plates (a 3/16” spacing):This water supply pipe arrangement works well in practice and it looks surprisingly like the gas take-off pipewhich has a series of holes drilled along the top of it:This arrangement works well as it allows large volume gas flow out of the cell and yet makes it difficult for anysplashes of electrolyte to make it into the pipe.Connecting to the Engine:The Bob Boyce hydroxy gas system produces such a very high gas output that one inch (25 mm) pipes areneeded to carry the gas from the electrolyser to the engine. Because of the speed of the pressure wavecaused if hydroxy gas ignites, no pop-off or shatter-disc system has sufficient time to operate. In addition,Bob’s system produces the top grade of hydroxy gas and as that has the highest energy level possible, itexplodes spontaneously at a pressure of just 15 psi. To deal with this situation, and the very high rate of gasflow which has to be handled, two very robust bubblers and one particle filter need to be used on the outputof the electrolyser as shown here:For those people living in America, Bob recommends the use of this bubbler:36