CABLE ASSEMBLY INSTRUCTIONS - WES Components

More documents

Recommendations

Info

CABLE ASSEMBLY INSTRUCTIONSWEDGE COMPRESSIONSTEP 1.STEP 2.STEP 3.STEP 4.All parts of the connector are shown.Strip the cable inner conductor, dielectric, and jacket as per“RECOMMENDED CABLE STRIPPING DIM’S” in catalog.Slide the HEX NUT onto cable, then insert the CONTACTASSEMBLY under braid and jacket.Insert cable and parts into the MAIN BODY, then screw theHEX NUT until it is tight.
CABLE ASSEMBLY INSTRUCTIONSCLAMPSTEP 1.STEP 2.STEP 3.STEP 4.STEP 5.STEP 1.STEP 2.All parts of the connector are shown.Strip the cable inner conductor, dielectric, outer conductor, and jacketas per "RECOMMENDED CABLE STRIPPING DIM'S" in catalog.STEP 3. Thread the GASKET onto the cable until it is against thecable jacket.STEP 4.STEP 5.Thread the CLAMP NUT onto the cable until the A dimension is1–1.5 mm, then push the TOP HAT onto the outer conductor of cableinside as shown.Thread the MAIN BODY onto the CLAMP NUT and tighten theconnection with wrenches, hold the CLAMP NUT and turn only theMAIN BODY.
Page 6 and 7: CABLE ASSEMBLY INSTRUCTIONSSOLDER (
Page 8 and 9: CABLE ASSEMBLY INSTRUCTIONSCRIMPSTE
Page 10 and 11: CABLE ASSEMBLY INSTRUCTIONSCRIMP -
Page 14 and 15: CABLE ASSEMBLY INSTRUCTIONSCLAMP -
Page 18 and 19: CABLE ASSEMBLY INSTRUCTIONSCLAMPSTE
Page 20 and 21: CABLE ASSEMBLY INSTRUCTIONSSOLDER (

CABLE ASSEMBLY INSTRUCTIONS - WES Components

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?