New Features and Migration - dSPACE

■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■▼ Key Features of dSPACE Release 5.0▲■■■■■■■■■■• The absolute mode to capture absolute angle positions ofleading and trailing edges, and absolute start and end timestamps of an injection signal (absolute = relative to a definedstarting point)The slave DSP of the DS2211 can trigger interrupts on the DS2211using RTLib macros (not supported by the RTI). Refer to Basics ofDS2211 Interrupts in the DS2211 Features document.DS4330New RTlib functions are added to support the LIN 2.0 specification.The LIN 2.0 specification is not supported by the RTI LIN Blockset.New Implementation Features for MicroAutoBoxdSPACE Release 5.0 provides the following new implementationfeatures and enhancements for the MicroAutoBox:MicroAutoBox1401/1505/1507The new MicroAutoBox variant provides the same features as itspredecessor MicroAutoBox 1401/1505/1506. Additionally, it comeswith an ECU interface connector (4-pin LEMO connector) that providesaccess to the signals of ECU channel 2. ECU channel 1 still be onaccessed via the Zero Insertion Force (ZIF) connector.New Implementation Features for RTI CAN BlocksetdSPACE Release 5.0 provides the following new implementationfeatures and enhancements for RTI CAN Blockset:DS2202 supportExtended ID rangefor STD messagesThe RTI CAN Blockset supports the new DS2202 HIL I/O Board.The ID range has been extended for messages with the STD messageformat. RTI CAN Blockset now supports the range 0 … 2047.New Implementation Features for RTI CANMultiMessage BlocksetdSPACE Release 5.0 provides the following new implementationfeatures and enhancements for RTI CAN MultiMessage Blockset:MicroAutoBox andDS2202 supportRTI CAN MultiMessage Blockset now supports MicroAutoBox and thenew DS2202 HIL I/O Board.dSPACE Release New Features and Migration November 2005 19▲■■■■■■■■■■■■