Owners Manual - Drive Medical

lifetime limitedwarrantyYour Drive brand product is warranted to be freeof defects in materials and workmanship for thelifetime of the original consumer purchaser.This device was built to exacting standardsand carefully inspected prior to shipment. ThisLifetime Limited Warranty is an expression of ourconfidence in the materials and workmanship ofour products and our assurance to the consumerof years of dependable service.deluxe all-in-onewelded steelcommodeIn the event of a defect covered by thiswarranty, we will, at our option, repair or replacethe device.This warranty does not cover device failuredue to owner misuse or negligence, or normalwear and tear. The warranty does not extend tonon-durable components, such as rubberaccessories, casters, and grips, which are subjectto normal wear and need periodic replacement.If you have a question about your Drive device orthis warranty, please contact an authorized Drivedealer.EU Authorized RepresentativeDrive Medical LTDAinley’s Industrial EstateElland, West Yorkshire,United Kingdom HX5 9JPwww.drivemedical.com© 2006 Medical Depot, Inc. All rights reserved.Drive is a trademark of Medical Depot, Inc.Port Washington N.Y. 11050 USA Made in Chinawww.drivemedical.com

commode assemblyinstructions and precautions1. Before assembling seat and lid, allowtoilet seat and lid to reach roomtemperature if exposed to cold. This willhelp prevent the seat and lid clamps fromcracking while being assembled ontocommode back cross brace.2. Align the toilet seat clamps onto the backframe rail. (Both clamps should sitoutside the pail brackets). Push down onseat until clamps snap firmly into place3. Repeat the same process for the lid.4. When removing the seat or lid, alwaysremove lid first and then the seat. Toremove, grasp the back of the lid and/orseat and lift.5. Install commode bucket by dropping intobucket frame. Reverse to remove.Item # 11105-4Shownweight capacity: 300 lbs.BucketDrops infigure 1Seat ClampsBucketFrameBackFrame RailBackSupportadjusting leg height1. Before use, adjust height of each leg toyour specific needs, making sure all legsare at the same height. When desiredheight is reached, lock legs into place byaligning buttons into proper holes, perfigure 2.2. To be sure legs are locked into place bypushing down on or by pulling legs.figure 2additional precautions1. Toilet seat must be in down positionbefore use. Failure to do so may result inbreakage of commode andpossible injury.2. Do NOT install commode without firstreading and understanding this assemblyand instruction sheet. If you can notunderstand these instructions, contact ahealthcare, dealer or technicalprofessional before attempting to install.Otherwise, injury or damage may occur.3. Inspect all parts for shipping damagebefore assembly. If there is shippingdamage - DO NOT USE. Contact dealer/carrier for further instructions.4. Make certain that the heightadjusting snap buttons fully protrudethrough the same respective hole of eachleg extension. This will ensure that theleg extensions are securely locked inposition and an even height is achieved(see Figure 1).5. Ensure ALL screws, nuts and/or boltsare tightened.6. Check the rubber tips on the legextensions for rips, wear or if they areare missing. Immediately replace any orall if any of these imperfections exist.7. All four leg extensions with rubber tipsMUST touch the floor simultaneouslyat all times.8. Users with limited physical strengthshould be supervised or assisted whileusing commode.