AquaBuOY scale 1:10 - Energinet.dk

More documents

Recommendations

Info

Prototype testing Oregon USADuring the spring and summer of 2007 the design and building of the 1:2 scale model took place in OregonUSA by companies hired by Finavera renewable. The speed and efficiency in getting the project up andrunning was quite remarkable seen with European eyes. Only about one and a half month after the projectmanager Denis from USA had been witnessing the installation of the 1:10 scale system in Nissum Bredning,he was ready to install the 1:2 scale model on the west coast of the USA September 1 2007.AquaBuOY 1:2 construction and prototype testing in USA, Oregon September 2007 [5]13
References:[1] Energi från havets vågor, Lennart Claeson mfl, Technocean AB, 1987[2] First Symposium on Wave Energy Utilization, 30 October –1 November 1979[3] Proceedings of the 2 nd International Symposium on Wave Energy Utilisation, The Norwegian Institute ofTechnology, Trondheim Norway June 22-24, 1982[4] AquaBuOY Wave Energy Converter, real sea testing at Nissum Bredning Denmark September 2007,Dep. of Civil engineering, Aalborg University[5] Finaveras webpage www.finavera.com14
Page 1 and 2: AquaBuOY scale 1:10Test in Nissum B
Page 3 and 4: Introduction:This R&D project invol
Page 5 and 6: Scope and ObjectivesooooTo build a
Page 7 and 8: Choice of end-stop solution the by-
Page 9 and 10: Methodology used installing of the
Page 11 and 12: Results and conclusionThe 1:10 scal
Page 13: 1:50 Scale Experiment HMRC CorkTo v

AquaBuOY scale 1:10 - Energinet.dk

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?