Download PDF

7SPAccessoriesR100 menus0. GENERALSee the operating instructions for the R100.1. OPERATION• Operating mode• Actual trip• Actual warning 1• Actual warning 2• Alarm log 1• Alarm log 2• Alarm log 3• Alarm log 4• Alarm log 5.2. STATUSDisplay of• Supply overview• Average current• Average voltage• Tempcon sensor• Pt100/Pt1000 sensor• Power input and energy consumption (described inthe following)• Energy trip counter• Phase sequence• Current unbalance• Operating hours and number of starts• Trip counter of hours and starts• Starting capacitor• Run capacitor• Insulation resistance• Cos • Harmonic distortion.3. LIMITSDisplay and setting of warning and trip limits.• Tempcon sensor• Pt sensor• Tripping current• Current warning• Nominal voltage• Voltage limits• Current unbalance• Starting capacitor• Run capacitor• Insulation resistance• Cos trip• Cos warning.4. INSTALLATIONSetting and display of• Supply mains• Trip class (described in the following)• Trip delay• External current transformers• Power-on delay• Restarting (described in the following)• Automatic restarting (described in the following)• Tempcon sensor• Pt sensor• Insulation resistance measurement• PTC/thermal switch• Resetting of trip counters• Service interval• Number of automatic restarts• Units/display• MP 204 display• GENIbus ID number• Learning function.Power input and energy consumptionActual input power and motor energy consumption.The energy consumption is an accumulated valuewhich cannot be reset.The power is calculated like this:U L1 – L2+ U L2 – L3+ U L3 – L1U average= ------------------------------------------------------------------------------------- V3I L1+ I L2+ I L3I average= -------------------------------------- A3cosaveragecosL1+ cosL2+ cosL3= --------------------------------------------------------------------------- -3P = U average I average 3 cosaverageW90