FOR DOUBLE-HUNG WINDOWS USING FRAME ... - Pella.com

More documents

Recommendations

Info

E. Pre-drill installation screw holes in the sillattachment clips. two holes in each clip. The holes should be located interior edge of the clip. F. Install the sill attachment clips (provided)into the sill of the double-hung window. Usea mallet or hammer to drive the clips into theaccessory groove at the sill.Two and Three Wide Units: Place one clip mullion and an additional clip centered mullion.Single Units: Place one clipcentered on the sill.3 SETTING AND FASTENING THE WINDOWA. Slide the window into the opening. Place the bottom of the window on the spacers atthe bottom of the opening. Position the window so that the exterior face of the frame installation screw holes in the jamb. This will hold the window in place while shimmingit plumb and square.B. Place shims at each installation screw hole between thewindow and rough opening. Adjust the shims as required toplumb and square the window in the opening.Note: DO NOT shim between the window sill and the roughopening. DO NOT over shim.3BC. Drill 5/32” pilot holes through the head and jamb screwinstallation holes, and through the shims. DO NOT drill intothe wood framing.Note: Raise the lower sash to access the bottom installationscrew holes. Windows with frame height >62” will have six holesper side, all other windows will have four holes per side.
D. Fasten the window in the opening through the installation holes and the shims and into thewall members. DO NOT over tighten. Over tighteningwill distort the frame and may interfere with theperformance of the window.E. Insert a plastic screw cover into each installation screw hole in the jambs.F. Locate the jamb adjusting screw in the sash track, justabove the bottom sash. Turn the screw clockwise untilit is flush or slightly below flush with the surface of thesash track to prevent interference with the balance.3DShim#10 x 2"screw3EShimScrewcover Fasten the sill through each pre-drilled holes in the sill clips. Check window operation. Lock and unlock the window. Raise and lower both sash.Note: If there are any problems with the operation of the window, recheck shimlocations and adjust for plumb and square.4 SEALING THE WINDOW TO THE EXTERIOR WALL CLADDINGNote: The sealant details shown are standard re<strong>com</strong>mendations from the sealant industry.Contact your sealant supplier for re<strong>com</strong>mendations and instructions for these and anyother applications.
Page 1 and 2: Vinyl Windows and DoorsManufactured
Page 3: 2 PREPARE THE WINDOW FOR INSTALLATI
Page 7: CLEANING INSTRUCTIONSRemove labels

FOR DOUBLE-HUNG WINDOWS USING FRAME ... - Pella.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?