Hoyt USA Recurve Manual 2000

Then, adjust the weight up anddown with the weight/tiller boltAlignment Locking Screwuntil the weight is where youdesire. Then simply tighten theweight/tiller locking screw, alignmentlocking screw and thumb ScrewThumbscrew finger tight, and you areready to shoot.WARNING: ALWAYS loosenthe thumb screw and alignment locking screw when adjustingweight or tiller on the Axis riser. Failure to comply willcause damage to the pocket. NOTE: To loosen the thumbscrew after shooting, you may use a coin in the screw slot.TillerTiller is the difference in draw weight between the upperand lower limbs. This is easily measured by noting thedifference in distance between the top limb butt to thestring, and the lower limb butt to the string. To settiller, measure the distance from the base of the limbpockets to the bow string on both the top and bottombow limbs. The main function of tiller is toallow the archer to more easily and comfortablyaim during the draw and release of the shot. Wheninitially putting your bow together, we recommendyou begin with 1/8”-1/4” positive tiller. (Bottommeasurement 1/8”-1/4” less than top measurement.)TopTillerBraceHeightTiller can then be adjusted to fit each individual. Ifyou find your sight moving up as you are drawing,increase the bottom limb poundage slightly, ordecrease the top limb poundage. If the sight is movingdown as you draw, make the opposite adjustments.To adjust the tiller without affecting bowBottomTiller10