Select Series - Clear Creek Spas

www.clearcreekspas.comOPERATIONThe spa will automatically begin to operate when electrical power is applied. There is no ON/OFF switch for thespa system.The control system has been designed so that by connecting the spa to its properly grounded power source, thespa's set temperature is preset to 100°F. Your spa's readout will display the water temperature, and the spa will heat tothe set temperature. The first filter cycle will begin one minute after the spa is energized.Control PanelThe control panel is easy to use with fingertip control of all the spa's functions. Control of temperature, jets andspa light is readily accessible from within the spa.WATER TEMPERATURE READOUTSelectSERIESStatus/Heat••••••TEMPERATURE JETS LIGHTSTemperature ControlsThe current temperature is constantly shown on thedisplay. After pressing the button once, the display willshow the set temperature. Pressing the button a secondtime will cause the set temperature to increase ordecrease depending on what direction was last chosen.Each successive press will change the set temperaturein the same direction.If the opposite direction is desired, release thebutton and let the display revert to the actual watertemperature. Press the pad to display the set temperatureand again to make the temperature change in thedesired direction.Temperatures from 80° to 104°F can be set.Jets ControlPress the button once to activate the lowspeedjet operation. Press the button again for the highspeedjet operation, and again to deactivate the jets.The low-speed jet operation will start automaticallywhen the heater is turned on or when a filter cycle isactivated. When a freeze condition is detected, highspeed jets are automatically activated.Whenever the low-speed is energized with thisbutton, it will automatically turn off after 4 hours ofoperation. The high-speed automatically turns OFFafter 30 minutes.LightThelight.button activates and deactivates the spaThe spa light will automatically turn OFF after 4hours of operation.