Select Series - Clear Creek Spas

www.clearcreekspas.comTROUBLESHOOTING GUIDEPROBLEM5. Noisy pump and motor.6. Water leakage at pump shaft(rotating connection betweenpump and motor).7. Motor will not start.8. Motor stops.PROBABLE CAUSEA. Clogged strainer(s).B. Leakage of air into suction line.C. Vibrating parts attached tomotor or support brackets.D. Low water level.E. Damaged or worn motor bearings.F. Impeller rubbing inside case.G. Debris inside pump.A. Worn or damaged pump seal.A. Power OFF.B. House circuit breaker tripped orin OFF position.C. GFCI tripped.D. Subnormal voltage.E. Improper or defective wiring.F. Locked shaft or impeller.G. Motor windings burned out.H. Defective starting switch insidemotor.A. Motor overload condition.B. Inadequate supply wiring.REMEDYA. Clean strainersB. Locate and repair leaks.C. Tighten fasteners.D. Add water to normal level.E *F. *G. *A. *A. Turn ON power at service panel.B. Reset circuit breaker.C. Reset GFCI.D. Call an electrician or your powercompany.E. *F. *G. *H. *A. Let cool for one hour. Motoroverload will reset; if problempersists, see *Note.B. Consult electrician to correctwiring to unit.*NOTE: The skills and tools necessary for the safe repair of this spa require the services of qualified servicepersonnel. Contact your Jacuzzi Whirlpool Bath dealer.