Windows 2000 Installation Guide - FTDI

More documents

Recommendations

Info

19 Windows 2000 Installation Guide4.3 Driver installation fails and Windows 2000 gives error code 10Windows error code 10 indicates a hardware error or failed driver installation. This error mayappear if a device has insufficient power to operate correctly (e.g. plugged into a bus powered hubwith other devices), or may indicate a more serious hardware problem. Also, it may be indicative ofUSB root hub drivers being incorrectly installed.Please refer to the example schematics on the FTDI web site for standard device configurations. Ifthe error persists, please contact the FTDI support department.© Future Technology Devices International Ltd. 2006
Troubleshooting204.4 FT232BM or FT245BM device hangs randomly during operationunder Windows 2000This is not caused by the driver, but is a hardware compatibility problem. Some newer USB 2.0hubs and host controllers can be susceptible to noise and can cause random device failures. Thiscan be overcome by fitting 47pF capacitors to ground on the USBDP and USBDM lines on the USBconnector side of the 27W series resistors.© Future Technology Devices International Ltd. 2006
Page 1 and 2: Future Technology DevicesInternatio
Page 3 and 4: Welcome to the Windows 2000 Install
Page 5 and 6: Installing FTDI Device Drivers42.1
Page 7 and 8: Installing FTDI Device Drivers6· C
Page 9 and 10: Installing FTDI Device Drivers8· W
Page 11 and 12: Installing FTDI Device Drivers10·
Page 13 and 14: Installing FTDI Device Drivers12·
Page 15 and 16: Uninstalling FTDI Devices143 Uninst
Page 17 and 18: Uninstalling FTDI Devices16© Futur
Page 19: Troubleshooting184.2 Windows 2000 f
Page 23 and 24: Contact Information226 Contact Info
Page 25: Index 24Index- D -Drivers 3, 4, 17,

Windows 2000 Installation Guide - FTDI

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?