Coke - Timcal

trueEC safety data sheetTrade name: TIMREX CokeCurrent version : 1.5.0, issued: 23.04.2012 Replaced version: 1.4.1, issued: 14.02.2012 Region: GBSECTION 7: Handling and storage7.1 Precautions for safe handlingAdvice on safe handlingProvide good ventilation of working area (local exhaust ventilation, if necessary). If workplace exposure limits areexceeded, respiratory protection approved for this particular job must be worn.General protective and hygiene measuresDo not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Avoid contact with eyes andskin. Remove soiled or soaked clothing immediately. Wash hands before breaks and after work. Do not inhale dust.Provide eye wash fountain in work area.Advice on protection against fire and explosionDust can form an explosive mixture with air. Take precautionary measures against static charges. Keep away fromsources of heat and ignition.7.2 Conditions for safe storage, including any incompatibilitiesTechnical measures and storage conditionsKeep container tightly closed and dry.Requirements for storage rooms and vesselsContainers which are opened must be carefully resealed and kept upright to prevent leakage. Always keep incontainers of same material as the original one.Advice on storage assemblyNone known7.3 Specific end use(s)No data available.SECTION 8: Exposure controls/personal protection8.1 Control parametersOccupational exposure limit valuesNo Substance name CAS no. EC no.1 DUSTList of approved workplace exposure limits (WELs) / EH40total inhalable dustTWA 10 mg/m³List of approved workplace exposure limits (WELs) / EH40respirable dustTWA 4 mg/m³8.2 Exposure controlsAppropriate engineering controlsNo data available.Personal protective equipmentRespiratory protectionIf workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. Incase of dust formation, take appropriate measures for breathing protection in the event workplace threshold valuesare not specified. Dust maskRespirator FFP2SL (EN 149)Eye / face protectionSafety glasses with side protection shield (EN 166)Hand protectionSufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of riskof skin contact with the product . Before use, the protective gloves should be tested in any case for its specific workstationsuitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to themanufacturer’s instructions and information relating to the use, storage, care and replacement of protective gloves.Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoidpermanent use of protective gloves.Page 3 of 8