Weekly Testing of Dedicated Smoke Control Dampers - Metasys ...

More documents

Recommendations

Info

The Damper 6-1 MCO Action Table is shown in Figure 10. The Damper Autopoint is a binary point in the field controller to indicate that the damper is underautomatic smoke control. When a fire fighter moves the FSCS Damper 1 toggleswitch to Opens or Close, the Damper Auto point is turned off. The DamperCommand is a point in the field controller to control the damper.Figure 10: Damper 6-1 MCO Action Table18Weekly Testing of Dedicated Smoke Control Dampers - Metasys® System Extended ArchitectureApplication Note
Weekly Dedicated Damper TestThe Dedicated Damper Test (Figure 11) system logic block inputs are two binarypoints that enable the damper Open and Close tests, three points from the fieldcontroller and a failure reset. Outputs are a binary point to indicate damper failure,and an MCO that commands the field controller to open or close the damper.Figure 11: Weekly Dedicated Damper Test Main ScreenThe Dedicated Damper Test block expanded logic is shown in (Figure 12).Figure 12: Dedicated Damper Test Block Expanded LogicWeekly Testing of Dedicated Smoke Control Dampers - Metasys® System Extended ArchitectureApplication Note19
Page 1: Weekly Testing of Dedicated Smoke C
Page 4 and 5: Application OverviewThis applicatio
Page 6 and 7: Security Administration SystemThe S
Page 8 and 9: 4. Fire Limited - This is the lowes
Page 10 and 11: • A Programming In Progress BV po
Page 12 and 13: Field Controller PointsField Contro
Page 14 and 15: Damper 6-1The Damper 6-1 main logic
Page 16 and 17: The expanded damper FSCS block logi
Page 20 and 21: The Weekly Damper Test Interlock De
Page 22 and 23: If the damper test fails, the failu
Page 24 and 25: The Damper Auto Status Interlock De
Page 26 and 27: Weekly Dedicated Damper Test Alarm
Page 28 and 29: If the damper test fails, the dampe
Page 30: Weekly Test ScheduleThe Weekly Test

Weekly Testing of Dedicated Smoke Control Dampers - Metasys ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?