Home-immediately access 800+ free online publications. Download ...

More documents

Recommendations

Info

51033-BKdribbler trough against theRocker Bar. It is attached at oneend to the dribbler as shown and theother end is attached to the insidewall of the mill. The end attachedto the mill wall should be about1/2" lower than the end attached tothe dribbler.http://www.cd3wd.com/CD3WD_40/VITA/FLOURMIL/EN/FLOURMIL.HTM (16 of 40)10/8/2009 3:52:09 PM
51033-BK(11) The grain hopper base is attached to the left side of the mill body byhfm011.gif (600x600)the use of two butt hinges. The hinges should have about a 1" long pinand 1" long leaf. The purpose of this manner of attaching the grain hopperis to make it possible to adjust the clearance between the grain hopperspout and the dribbler trough. See parts 11 and 17.http://www.cd3wd.com/CD3WD_40/VITA/FLOURMIL/EN/FLOURMIL.HTM (17 of 40)10/8/2009 3:52:09 PM
Page 1 and 2: 51033-BKHome-immediately access 800
Page 3 and 4: 51033-BKUse 1/2" thickness good qua
Page 5 and 6: 51033-BKaccurate. Use epoxy glue in
Page 7 and 8: 51033-BK(4) Center Bulkhead. Overal
Page 9 and 10: 51033-BK3/8 inch thickness grinding
Page 11 and 12: 51033-BKStove bolt is 3/16" by 2".
Page 13 and 14: 51033-BKinto the buhrs.(9) Rocker B
Page 15: 51033-BKpart helps to deflect the m
Page 19 and 20: 51033-BKleft side of mill body by t
Page 21 and 22: 51033-BKUse two pieces each 3/4" th
Page 23 and 24: 51033-BKUse one piece of 1" thickne
Page 25 and 26: 51033-BKstationary buhr is removed.
Page 27 and 28: 51033-BKhardened cement walks or sl
Page 29 and 30: 51033-BKmill reduce the 10" dimensi
Page 31 and 32: 51033-BKpart. The auxiliary sketch
Page 33 and 34: 51033-BK(21) Buhr Adjustment Screw.
Page 35 and 36: 51033-BKthe shaft more snugly. Befo
Page 37 and 38: 51033-BK(26) Meal Bin.hfm026.gif (1
Page 39 and 40: 51033-BKVITA Technical Bulletins of

Home-immediately access 800+ free online publications. Download ...

Create successful ePaper yourself

Delete template?

Save as template?