Home-immediately access 800+ free online publications. Download ...

More documents

Recommendations

Info

51033-BKUse 3/4" thickness pine lumber. Make the foot 1 1/2" high and 15 1/2" long.Bore 1/4" to suit matching holes in details #1 and #2.(23) Use two steel washers with one copper washer between.(24) Bronze Bearing. This can be a standard bronze sleeve bearing acquired ata bearing supply store, or it can be simply a short length of copper waterpipe. If the light gauge pipe is used, it will be advisable to use a hacksawto cut the piece lengthwise and remove about 1/8". Then compress it to fithttp://www.cd3wd.com/CD3WD_40/VITA/FLOURMIL/EN/FLOURMIL.HTM (34 of 40)10/8/2009 3:52:09 PM
51033-BKthe shaft more snugly. Before installing, roughen the outer surface to holdthe epoxy better. The bearings should be put in place only after the body ofthe mill is permanently assembled and epoxy is hard. Put the bearings inplace using epoxy. Then slip the shaft thru before epoxy hardens. With thisprecaution, the bearings will be held in alignment.Still another way to provide the bearing is to make a bearing entirely ofepoxy. Bore a 1" diameter hole for the shaft, make a collar to hold the shaftexactly in the center of the hole in parts (3) and (4) then with the shafthfm001.gif (600x600)http://www.cd3wd.com/CD3WD_40/VITA/FLOURMIL/EN/FLOURMIL.HTM (35 of 40)10/8/2009 3:52:09 PM
Page 1 and 2: 51033-BKHome-immediately access 800
Page 3 and 4: 51033-BKUse 1/2" thickness good qua
Page 5 and 6: 51033-BKaccurate. Use epoxy glue in
Page 7 and 8: 51033-BK(4) Center Bulkhead. Overal
Page 9 and 10: 51033-BK3/8 inch thickness grinding
Page 11 and 12: 51033-BKStove bolt is 3/16" by 2".
Page 13 and 14: 51033-BKinto the buhrs.(9) Rocker B
Page 15 and 16: 51033-BKpart helps to deflect the m
Page 17 and 18: 51033-BK(11) The grain hopper base
Page 19 and 20: 51033-BKleft side of mill body by t
Page 21 and 22: 51033-BKUse two pieces each 3/4" th
Page 23 and 24: 51033-BKUse one piece of 1" thickne
Page 25 and 26: 51033-BKstationary buhr is removed.
Page 27 and 28: 51033-BKhardened cement walks or sl
Page 29 and 30: 51033-BKmill reduce the 10" dimensi
Page 31 and 32: 51033-BKpart. The auxiliary sketch
Page 33: 51033-BK(21) Buhr Adjustment Screw.
Page 37 and 38: 51033-BK(26) Meal Bin.hfm026.gif (1
Page 39 and 40: 51033-BKVITA Technical Bulletins of

Home-immediately access 800+ free online publications. Download ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?