TM 9-2920-243-34

TM 9-2920-243-34d. Remove brushes following instructionsprovided in paragraph 3-11c. Remove armatureand discard sandpaper. Clean armature andbrushes (para 3-13c and d).e. Refer to paragraph 3-10 and reverse removalinstructions for installation of armature andthrust washers.f. Refer to paragraph 3-11a through c andreverse removal instructions for installation ofbrushes and brush opening band.NOTERemove screw (B, fig. 3-35) beforesecuring brushes.Figure 3-38. Examples of satisfactory and unsatisfactory brush seats.3-21. Shift Housing AssemblyRefer to paragraph 3-9 and reverse disassemblyinstructions for assembly of shift housingassembly.3-22. Shaft and Lever AssemblyRefer to paragraph 3-8 and reverse disassemblyinstructions for assembly of shaft and leverassembly.3-23. Installation of Shift Housing Assemblya. Refer to paragraph 3-7 and reverse removalinstructions for installation of shift housingassembly. Make certain scribe marks (A, fig. 3-10)on field ring and shift housing assembly arealined.b. Check armature end play as shown in figure3-39. End play must be 0.015 to 0.070 inch. If endplay is excessive, disassemble starter (para 3-7and 3-10), replace thrust washer, and assemble,(para 3-20).Figure 3-39. Measuring armature end play.3-24. Assembly and Installation of PinionHousing Assemblya. Assembly. Refer to paragraph 3-6b andreverse disassembly instructions for assembly ofpinion housing assembly.b. Installation. Refer to paragraph 3-6a andreverse removal instructions for installation ofpinion housing assembly. Make certain alinementmarks (A, fig. 3-5) on shift and pinion housing areproperly alined.NOTEThe same starter assembly is used onboth the LDS-465, LDT-465, LD-465 and3-17