BEL980 & BEL950 - Beltronics

More documents

Recommendations

Info

as an option on some vehicles. This type of windshield makesany dash, visor or windshield mounted detector ineffective.(If in doubt, check with an appropriate dealership to see ifthis applies to your vehicle.) To achieve optimum performance,regardless of which mounting position you choose, followthe basic steps on the following page.1. Consider occupant safety when selecting a mounting location.Choose a location where the unit will not be hazardous incase of an accident.2. For optimum detection, position your unit with a clear,unobstructed view of the road from the front and rear.3. Do not allow the unit to make contact with the windshield.This will eliminate unnecessary vibration.4. Avoid placing your unit in direct sunlight. During the summer,interior temperatures of an enclosed vehicle can sometimesreach temperatures that will cause premature aging of the unit.5. Your detector is not waterproof; exposure to water may causedamage and your warranty will be void.Dash MountingYou can mount your unit to a level area of your vehicle’s dashusing the hook and loop fastener or the four, non-skid dashmounting pads provided.Windshield Bracket AssemblyThe visor clip is fullyassembled. To assemble thewindshield bracket, follow thediagram.Windshield Mounting1. Remove the mounting bracketcover on top of the unit byWindshield Bracket Assemblypressing on the raised dots andpushing outward. Store the cover in a safe place.12
2. Clean the selected windshield area, position the suction-cupmount on the windshield, and press firmly on each suctioncup to secure it in place.3. Use a screwdriver or a small coin to adjust the angle of thesuction-cup mount until the base plate is level.4. Slide detector onto base plate until it snaps into place.Note—some vehicles have a plastic coating on the inside of thewindshield designed to protect occupants in case of an accident.Use of the windshield bracket on this type of windshield canpermanently mark the surface. Check with your dealer if youare unsure whether your vehicle is equipped with this type ofwindshield.Visor Mounting1. Remove the mounting bracket cover by pressing on theraised dots and pushing outward. Store the cover in asafe place.2. Slide the visor clip onto the top of the detector until it snapsinto place. Clip the detector to the edge of the sun visor nearestthe windshield.13
Page 1 and 2: Advanced PROTECTION System®®®®w
Page 3 and 4: table of contentsProfile of Feature
Page 6 and 7: Q-START (Quick-Start Mode)Unit will
Page 8 and 9: Volume ControlPress and hold the au
Page 10 and 11: X/K/Ka Band On or Off (bel 980 only
Page 14 and 15: Fuse Replacement1. If the fuse has
Page 16 and 17: Since Radar signals travel in a str
Page 18 and 19: Instant-On/Pulsed RadarThis type of
Page 20 and 21: “Moving”confirms Emergency/Slow
Page 22 and 23: consumer warranty2-year Warranty-be
Page 24: list of accessoriesdescriptionmodel

BEL980 & BEL950 - Beltronics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?