BM Polyco Puncture Resistant Gloves - Catalogue - Reid Brothers

Explanation of Standards used within this category(further explanation can be found at the front of this catalogue)Mechanical Hazards EN388Ratinga) Resistance to abrasion 0-4b) Blade cut resistance 0-5c) Tear resistance 0-4d) Puncture resistance 0-4 abcdChemical and Micro-Organism EN374RatingEN374-2 Resistance to penetration by 1-3micro-organisms. Referred toas acceptable quality level (AQL)EN374-3 Resistance to chemical hazards 1-6Protection from Cold EN511Ratinga) Resistance to convection cold 0-4b) Resistance to contact cold 0-4c) Permeability to water 0-1abcFor Minimal Risk OnlyGloves of simple design offer protection from low level risks, e.g. janitorial gloves.Manufacturers are permitted to test and certify the gloves themselves.Gloves of this category are CE-marked as follows:For Minimal Risk OnlyiThe higher the score, the better the performance.0 represents a fail - X denotes no test was carried out.130