INSTALLATION GUIDE - Hubbell Power Systems

More documents

Recommendations

Info

Recommended Installation ProcedureStep 19. Installing Wood DiaphragmsNOTE: THIS IS REQUIRED!Slide lumber spacers (can trim for shorter channelsor let extend through grates) into appropriateslots found in frame. All 4 slots in each individualframe must contain a diaphragm to ensure desiredresults. This procedure must be completed for theentire drain system.PROCEDUREStep 20. Wrap GratesWrap grates in plastic and place onframes of system before concreteis poured.- 12 -
Recommended Installation ProcedureStep 21. Pour Concrete and FinishPour concrete and after theconcrete has achieved sufficientcure, remove grates anddiaphragms. Knock off protruding endsof dry wall screws(a hammer works well for this).NOTE: Do not radius the edge of theconcrete adjacent to the drain.NOTE: Concrete encasement can beplaced in a single lift.Step 22. Clean UpAfter excess screw threads have been removed, unwrapgrates and place in frames. If locking devices arerequired, install them at this time(see Detail 22A).PROCEDURE- 13 -
Page 1 and 2: INSTALLATION GUIDE®3000Fit channel
Page 3 and 4: Installation Benefits• POLYCAST
Page 5 and 6: Recommended Installation ProcedureS
Page 11: Recommended Installation ProcedureS
Page 15 and 16: Typical Installation DetailsDETAILS

INSTALLATION GUIDE - Hubbell Power Systems

Create successful ePaper yourself

Delete template?

Save as template?