Masport Walk Behind

GAPLEVER STOPCAM4. Set cut height adjuster off lowest point, the lid should close. Onthe higher cut height setting the lid should be closed and a smallgap of approximately 0.5mm to 1mm should be between the Camand Latching Lever.PERIODIC MAINTENANCE CHECKSLATCHINGLEVERLATCHINGLEVERGAPLEVERSTOP5. If the Lid does not close or there is no gap between Cam andLatching Lever when the cable is slack. Remove the Cover usingthe two M5 x 10 Phillips pan head screws.ADJUSTINGM5 BOLTA. Pull Latching lever forward and release, it should return easilywith the spring action, if it is clean and does not return smoothlyrelease the M8 lock nut slightly till it moves easily.B. If the lever is too sloppy, tighten the nut until it moves freelywithout sticking.C. Keep the leavers clean and a light silicone spray will keep yourchipper closer working smoothly.6. And tighten the fine tune adjustment M5 bolt and nut.ADJUSTINGM5 BOLT7. Fit cover back with M5 x 10 Phillips pan head screws as shownabove.19