NetBackup 5230 Appliance Initial Configuration Guide - 2.6.1.1

Recommendations

Info

Chapter2Initial configurationproceduresThis chapter includes the following topics:■■■■Performing the initial configuration on a NetBackup 52xx appliance from theNetBackup Appliance Web ConsolePerforming the initial configuration on a 52xx master server appliance from theNetBackup Appliance Shell MenuConfiguring a master server to communicate with an appliance media serverPerforming the initial configuration on a 52xx media server appliance from theNetBackup Appliance Shell MenuPerforming the initial configuration on a NetBackup52xx appliance from the NetBackup Appliance WebConsoleAfter you have installed, connected, and turned on all appliance system components,you are ready to configure the server.If you plan to configure this appliance as a media server, complete the followingtasks on the master server before you start the initial configuration. The followinglink provides specific instructions about how to accomplish the necessary tasks:See “Configuring a master server to communicate with an appliance media server”on page 56.■Make sure that the master server and this media server have compatible softwareversions.
Initial configuration proceduresPerforming the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console33■■■Add the name of this media server to the master server that you plan to usewith it.If a firewall exists between the master server and this media server, open theappropriate ports as described in the link above.Make sure that the date and time of this media server matches the date andtime on the master server.The following procedure describes how to configure a new or a reimaged appliancefrom the NetBackup Appliance Web Console.Caution: Before or immediately after initial configuration, change the defaultmaintenance password (P@ssw0rd) for the appliance. This password must beprovided to Symantec Technical Support in case you need future troubleshootingassistance. Change the maintenance password through the NetBackup ApplianceShell Menu with one of the following commands: Main > Settings > Passwordmaintenance or Main > Support > Maintenance > passwd. For completeinformation, see the Symantec NetBackup Appliance Command Reference Guide.To perform the initial configuration on a NetBackup 52xx appliance from theNetBackup Appliance Web Console1 On the laptop that is connected to the NIC1 appliance port, navigate to theLocal Area Connection Properties dialog box.On the General tab, select Internet Protocol (TCP/IP) so that it is highlighted,then click Properties.
Page 1: Symantec NetBackup 5230Appliance In
Page 6 and 7: Support agreement resourcesIf you w
Page 8 and 9: Chapter1Preparing for initialconfig
Page 10 and 11: Preparing for initial configuration
Page 16: Preparing for initial configuration
Page 31: Preparing for initial configuration
Page 35 and 36: Initial configuration proceduresPer
Page 57 and 58: Initial configuration proceduresCon
Page 69 and 70: Chapter3Post configurationprocedure
Page 71 and 72: Post configuration proceduresDownlo
Page 73 and 74: Post configuration proceduresInstal
Page 75 and 76: Post configuration proceduresInstal
Page 77: Index77Ppages in the NetBackup Appl

NetBackup 5230 Appliance Initial Configuration Guide - 2.6.1.1

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?