NetBackup 5230 Appliance Initial Configuration Guide - 2.6.1.1

Recommendations

Info

Initial configuration proceduresPerforming the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console44The following describes the supported proxy servers:■■■SquidApacheTMGNote: NTLM authentication in the proxy configuration is also supported.For Call Home, enter the appropriate Call Home Configuration informationas follows:Call Home Configuration data entry fieldsTo configure the appliance to send email reports to a proxy server or to the SymantecCall Home server, enter the following information:■■■Enable Call HomeClick this check box to enable the appliance to send email reports to the SymantecCall Home server.Enable proxy serverClick this check box to use a proxy server for email notification and provide theproxy information that follows.Enable proxy TunnelingTo enable proxy tunneling, click this check box and provide the following proxyinformation:■■■■■Proxy serverEnter the IP address of the server.The IP address can be either IPv4 or IPv6. For IPv6, only global-scope andunique-local addresses are allowed.Proxy portEnter the port number of the proxy server to allow communication with thisappliance.Proxy usernameEnter the user name for the proxy server.Proxy passwordEnter the password of the proxy server.Test Call HomeAfter you have entered all of the necessary information, Symantec recommendsthat you click Test Call Home to verify communication with the Symantec server.If the test fails, check that you have entered all names, IP addresses, and portnumbers correctly. If the test fails again, contact Symantec Technical Support.After you have entered all of the necessary information, click Next.
Initial configuration proceduresPerforming the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console4511 On the Registration page, enter the following information to register thisappliance with Symantec over the Internet:Note: Registration of your NetBackup appliance helps to make sure that youare alerted to product updates and other important information about yourappliance.Appliance nameCompany NameStreetCityState/ProvinceZip or Postal CodeCountryContact NameContact NumberContact EmailEnter the network name of the server.Enter your company name.Enter the street name (physical location) where thisserver resides.Enter the city where this server resides.Enter the state or the province where this server resides.Enter the ZIP or the Postal Code where this serverresides.Enter the country where this server resides.Enter the name of the primary contact, such as anetwork or a backup administrator for your backupenvironment.Enter the primary phone number for the contact name.This number should be the one that is most likely toreach the contact person.Enter the business email address for the Contact Namethat you identified earlier.After you have entered all of the necessary information, click Next.12 Configure the role for this appliance server as follows:
Page 1: Symantec NetBackup 5230Appliance In
Page 6 and 7: Support agreement resourcesIf you w
Page 8 and 9: Chapter1Preparing for initialconfig
Page 10 and 11: Preparing for initial configuration
Page 16: Preparing for initial configuration
Page 33 and 34: Initial configuration proceduresPer
Page 43: Initial configuration proceduresPer
Page 57 and 58: Initial configuration proceduresCon
Page 69 and 70: Chapter3Post configurationprocedure
Page 71 and 72: Post configuration proceduresDownlo
Page 73 and 74: Post configuration proceduresInstal
Page 75 and 76: Post configuration proceduresInstal
Page 77: Index77Ppages in the NetBackup Appl

NetBackup 5230 Appliance Initial Configuration Guide - 2.6.1.1

Create successful ePaper yourself

Delete template?

Save as template?