Water-Ingress- Detection-System - Weser Flow Control

Water-Ingress-Detection-SystemWIDSWeser Flow Control Sensor WFC-WIDS 2This water ingress sensor is the recommended type and especially designed to detect water in cargoholds. Its technology is based on capacitive active shield sensing were sensor probe and vessel form thetwo electrodes of a capacitor. A capacitance change, effected by liquids wetting the probe, changes thecapacitive level which is processed by the integrated electronics and converted into a electronic signal.Because the capacitive measuring principle requires no special installation and mounting this method isvery reliable and manifold proved. The probe is installed in a protection pipe DN65 which is welded ormounted onto the inner cargo holding wall. The probe consists of two parts, the basic probe and the cord(length max. 20m) which connects the probe body with the gauge head. The basic probe is 2200mm longand due this both required levels, 0,5m and 2m are detected with only one sensor. The gauge head of thesensor is designed with a connection flange, for mounting the sensor direct onto the protection pipe. Duethat the probe is made of stainless steel and protected by the protection pipe extreme roughenvironments and temperatures from –40 up to +200°C are no problem. This design enables leveldetections of seawater, water, corrosive liquids or adhesive products without problems . The electronicpart is fully insulated. The biggest benefit is that is that this sensor is operating with only one probe, thismeans only one sensor is needed to detect two different levels and almost no particle can key or cant,which can interact the correct detecting. The mounting of the sensors is easy and the rugged constructionis the basis for an interference and maintenance free operation.Sensor features:• Pressure: 10 Bar ,• Temperature: - 40 ..+ 200°C• Material Type 1: Probe : 316L Stainless steel, Body : Aluminum epoxy coated.• Protection: on Deck IP 68, in Deck IP65, Ex-proofed ATEX II 1G EEx ia IIC T6• Power supply: DC 30V via zener barrier or transducer• Connection: G1” with Flange DN65• Electric connection: via PG 13,5 cable gland.Applications: Cargo holds, collision bulkheadWeser Flow Control GmbH - Konsul-Smidt-Str. 8U, 28217 Bremen - Amtsgericht Bremen HRB 27110 HB ⋅ Geschäftsführer: Michael Borchers+49 (0) 421 877 54 40 +49 (0) 421 877 53 95 homepage: http://www.weser-flow-control.com e-mail: info@weser-flow-control.comBremer Landesbank (BLZ 290 500 00) 10 52 37 50 02 S.W.I.F.T.-Code BRLADE22 IBAN-Nr. DE84 2905 0000 1052 3750 02