fire detection systems fire detection systems - coting.si - coting.si

Recommendations

Info

X-VULCAN CHARACTERISTICS STANDARD SHADOW SUPPLY VOLTAGE: CURRENT CONSUMPTION QUIESCENT: CURRENT CONSUMPTION ALARM: ADDRESS RANGE: TONES: PROTECTION RATING: ADDRESSABLE SOUNDERS 1 2 3 4 5 6 7 8 ON OFF SWITCHES 1-5: REGULAR ADDRESSES FROM 094 TO 125 IN BINARY ON OFF ON OFF ON OFF ON OFF ON OFF Pr.Id.:32533 PROGRAMMING DATA FOR ADDRESSABLE BASE SOUNDER 17-40 V DC 0.8 mA 3.5 mA 94 - 125 (32/Loop) SWITCH 6: OFF: IAS LOOP SOUNDER ON: APOLLO SOUNDER CIRCUIT CONTROLLER SWITCH 7 & 8: OFF: SWEEP SOUND (800 - 1000 Hz) SWITCH 7 ON & 8 OFF: ALTERNATE SOUND (2800 - 3500 Hz) SWITCH 7 OFF & 8 ON: ALTERNATE SOUND (800 - 1000 Hz) SWITCH 7 & 8: ON: CONTINUOUS (800 Hz) VULCAN ADDRESSABLE BASE SOUNDER Accepts APOLLO XP95 Detector Base. + 17-40 V DC 0.8 mA 3.5 mA SHADOW (64/Loop) 4 TONES SELECTED BY JUMPERS IP44 1 2 3 4 5 6 7 8 WEIGHT: 75 grams DIMENSIONS: DIAM.: 112 - HEIGHT: 37 (mm) SOUND OUTPUT- CONTINUOUS 85 dB @ 1 METRE SOUND OUTPUT- SWEEP: 85 dB @ 1 METRE SOUND OUTPUT- ALTERNATING: SOUND OUTPUT- HIGH PITCH: 85 dB @ 1 METRE 92 dB @ 1 METRE This sounder is an ultra low power base sounder, intended to be used both as a stand-alone low profile sounder, or as a combined detector plus sounder assembly. When configured as a SHADOW sounder, by cutting the appropriate link, these sounders become invisible to the fire alarm control panel. This characteristic means that although the panel can control the activation of the sounders - in up to 32 groups per loop - each of these groups can have more than one and up to 64 sounders because the devices are not reporting back to the panel. This also means that device addresses 94 to 125, hereto reserved for addressable sounders, can be concurrently used by other device types, i.e. detectors and call points, meaning that at this stage the total numbers of sounders per loop is raised to 64 together with up to 125 other devices, detectors etc... This implies that the sounders are NOT monitored individually, but solely as part of the detection loop. 13 _ _ ++ ++ _ _ X-VULCAN - A
SAM FEATURES Up to 125 SAM's can be connected to a loop SAM addresses are set by the test\commissioning sequence SAM's can be fitted to the same loop as any of our addressable modules SAM's can be fitted to the same loop as S90, XP95 and Discovery detectors SAM addresses can be erased and re-programmed SOFT ADDRESSABLE MODULE Fully encased for protection in high impact plastic Small dimensions: 41.5 x 24.5 x 10.5 (mm) Connections compatible with fork terminals or wire up to 1.5 mm2 Two versions available: SAM-S for Smoke detectors SAM-H for Heat detectors Following strategy of providing competitive products for our esteemed customers, we are pleased to announce the launch of SAM. This tiny, very low cost, module provides any conventional detector with an address without the inconvenience of using a manual addressing unit or DIP switch. The SAM is simply attached to the conventional detector and the detector address is automatically assigned to each SAM by the JUNO-NET or JUNiOr control panel during commissioning and testing. A SAM based system tolerates loop branches and can monitor loop interruptions and head removal. SAM is ideal for low budget retrofits where fire point identification is needed but the cost of fitting a fully analogue system is too high. SAM is also an option in low budget installations that would normally be implemented with 4 to 8 zone conventional systems. It gives you the cable savings possible (see below) with an addressable system, together with the loop sounder capability but without the extra costs of analogue addressable heads. Compatible with any make of conventional detector, the SAM is fully encapsulated in a plastic case, unobtrusive and easy to connect to the detector base. 3 2 Pr.Id.:32530 CONVENTIONAL PANEL INSTALATION CABLE REQUIRED: METERS 200 5 6 7 8 1 4 3 SAME INSTALATION USING JUNO-NET PANEL & SAM SYSTEM CABLE REQUIRED: METERS 78 2 4 5 6 7 8 A SAM system can prove economical as an alternative to conventional systems as small as 4 detection zones. Up to 125 detection devices can be fitted to a single loop of fireproof cable. This, together with the use of addressable loop powered sounders, keeps wiring costs to a minimum and gives the customer all the flexibility and programmability of an addressable system at an extremely competitive price. 14 1 4
Page 1: FIRE DETECTION SYSTEMS Product cata
Page 4 and 5: RAIK Pr.Id.:30100 1-3 loops analogu
Page 6 and 7: 1, 3 LOOP Juno-NET 100 Pr.Id.:30109
Page 8 and 9: J-NET-LOOPCON CHARACTERISTICS DIMEN
Page 10 and 11: or many fire alarm systems, all tha
Page 12 and 13: X-MCPA-KAC ELECTRICAL CHARACTERISTI
Page 16 and 17: X-IN X-I/O X-IN ELECTRICAL CHARACTE
Page 18 and 19: X- X-LSCISO TECHNICAL CHARACTERISTI
Page 20 and 21: X-IND CHARACTERISTICS WORKING VOLTA
Page 22: ACCESSORIES, GAS DETECTORS Air Samp

fire detection systems fire detection systems - coting.si - coting.si

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?