IPM 09 (Rev. 3)

More documents

Recommendations

Info

6. The ispLSI programming port The 12 pin connector AA of the IPM 09 is factory used for programming the onboard ispLSI device. This port can only be used for programming purposes with a special interface. Any other connections made to this port may cause permanent damage or not user recoverable malfunctions. ATTENTION: DO NOT MAKE ANY CONNECTIONS TO CONNECTOR AA ! Page 20 of 25 EW256MA-03AA Archivierung: 5 Datei: IPM 09AA.DOC © 1996 MicroSys Electronics GmbH and ikon GmbH
Datei: IPM09-ikon.DOC Archivierung: 5 EW256MA-03AA Page 21 of 25 © 1996 MicroSys Electronics GmbH and ikon GmbH
Page 1 and 2: ikon GmbH Benzstraße 17 89079 Ulm
Page 3 and 4: Datei: IPM09-ikon.DOC Archivierung:
Page 5 and 6: Datei: IPM09-ikon.DOC Archivierung:
Page 7 and 8: 1. Introduction 1.1 Short Descripti
Page 9 and 10: 1.5 IPM 09 Block Diagram Clock Ctrl
Page 11 and 12: 3. Installation 3.1 Items required
Page 13 and 14: 4.1.1 Address map with IO-Select ac
Page 15 and 16: 4.2 The Siemens ISDN chipset The IP
Page 17 and 18: 4.4 Configuration of the IOM-2 The
Page 19 and 20: 4.6 Pin assignment of the logical i
Page 21: 5. Versions and Jumper settings TE
Page 25 and 26: Appendix A: Layout Component side D
Page 27: Appendix C: Schematics Datei: IPM09

IPM 09 (Rev. 3)

Create successful ePaper yourself

Delete template?

Save as template?