SÜdmo FLow diversion device

SÜdmo FLow diversion devicewith the Intelltiop 2.0Product leafletGeneral Product informationThe Non-Slamming Flow Diversion Devicethat interfaces with the legal controlsystems for HTST operation is nowcontrolled by the IntelliTop 2.0, which usesproximity switches for position detectioninstead of microswitches. This is morerobust and ensures feedback repeatabilityin demanding process conditions.Set-up and testing of equipment is easierthan ever. The electronic IntelliTop 2.0control unit provides quick, push-buttonset-up. This eliminates the opportunityfor human error as in systems withmechanical switches. The control top’s 360degree beacon provides local indication ofthe valve position.The valves’ machined bodies offer a ruggedsolution with a maintenance-free actuator.The upper seat is made from a durableFDA compliant PEEK material, while thelower seat is a sliding o-ring made fromstandard FDA compliant seal materials.The rugged upper seat lengthens servicelife and helps eliminate the need forfrequent adjustment, while the radial lowerseal allows for easy maintenance.Benefits• Long wear PEEK upper seat• Sliding lower seat for ease ofmaintenance allowing complete removalfrom top of housing without stemremoval• Easy test procedure for inspectors - notnecessary to take valve apart for HTSTvalidation• 10-year prorated actuator warranty• Air connection with shut off valveincluded• No water hammer during divert toforward flow• O-rings (not V-rings) require no specialtools for seal insertion• IntelliTop 2.0 allows for quick set-up andeliminates microswitch adjustment• Beacon on control top indicates valveposition• IntelliTop 2.0’s IP 65/67/69K ratings meetwater tight needs in the process roomThe valve set carries the 3-A symbol andmeets the FDA Grade “A” PasteurizedMilk Ordinance (PMO) guidelines for FlowDiversion Devices as stated in M-b-347Supplement 1.Fluid process solUTIONSFlow diversion device

SÜdmo FLow diversion devicewith the Intelltiop 2.0Product leafletStandard specificationsMaterials- Product contact: 316L (1.4404)- Non product contact: 304 (1.4301)- Optional: Hastelloy, AL6XNSeals- Standard: EPDM / PEEK- Optional: HNBR, FPM (Fluoro-Rubber),FFPM (Perfluorinated Fluoro-Rubber)Operating Pressure- Control air pressure: Standard 87-116 psi- Optional: 50 psi- Product pressure: Standard 87 psi- Optional: 145 psiConnections- Standard: Sanitary O.D. tube clamp- Optional: Sanitary O.D. tube butt weldWelding ends for metric tubesWelding ends for ISO tubesDIN nutFinish-