EQUIPMENT

More documents

Recommendations

Info

4 Installation (continued)Caution!Do not operate with the unit resting on its side or at an angle greater than 15 degrees, frontto back.4.1.1 Lamp Installation – New UnitCaution!Do not touch the lamp module reflector or the lamp. Contaminants from hands will create “hotspots” and cause the module to fail prematurely. If either the lamp or reflector is accidentallytouched, carefully wipe them with a clean, soft cloth and isopropyl alcohol.1. Switch power off and unplugthe unit.Large Diameter Pin2. Remove four screws fromsides of housing and lift offthe cover.3. Pull back on the spring-loadedplunger and insert lampmodule into lamp mount plateand release plunger (seefigure 2).4. Remove the two power leadsfrom the foam block.5. Connect small diameter lead tofront of lamp and largediameter lead to back of lamp(see figure 2).6. Replace the cover andinstall screws.Spring Loaded PlungerLamp ModuleSmall Diameter PinOn Far Side Of LampLamp Mount PlateFigure 26
5 Operating the Unit5.1 Inserting and Removing the Light Guides☞Caution!Be sure to remove the plastic end caps before attempting to use the light guide.Caution!If the free end of the light guide is secured at a fixed location, sharp bends should be avoided asit will cause a decrease in UV power.Caution!Never pull on the jacketing portion of the light guide. During installation or removal, grasp thelight guide on the strain relief nearest the input end of the light guide.• Installing single light guide - Insert the large end of single light guide into the light guidereceptacle located on the left side of the front panel. Push light guide firmly until it isfully engaged.• Installing dual light guide – Insert the dual wand light guide into the light receptacle androtate the collar assembly so that the scribed line on the collar is in the 12 o’clock position.See section 5.4 “Adjusting Wand for Maximum Output.”Notice:It is important that the rotational position of a dual light guide be set to maximize the UV outputfor each wand. This setting is specific to each curing unit and light guide (See section 5.4 -Adjusting Dual Wand).5.2 Powering Up☞1. Plug the power cord into the receptacle located at the bottom left of the rear panel.2. Plug the cord into the 120V/60Hz outlet.3. Ensure that the lamp and light guide have been installed and the cover securely fastened.4. Install foot switch.5. Turn on the main power switch, the red switch will light up.6. Check the fans for airflow.7. Allow approximately five minutes for the lamp to reach full power.Notice:Avoid shutting the main power off for brief periods of time. Frequent start-ups will cause thelamp to decay at an accelerated rate. If the system is shut down, wait a minimum of ten minutesbefore restarting. Once the lamp is ignited, allow it to operate for a minimum of fifteen minutesbefore turning it off.7
Page 1 and 2: ®EQUIPMENTOPERATION MANUALLoctite
Page 3 and 4: 1 Please observe the following1.1 E
Page 5 and 6: 2 Description (continued)The exposu
Page 7: 3 Technical Data3.1 Energy Requirem
Page 11 and 12: OMRON4 3RESET2 15 Operating the Uni
Page 13 and 14: 6 Care and Maintenance☞☞☞Noti
Page 15 and 16: 8 Documentation8.1 Wiring DiagramSH
Page 17 and 18: 8 Documentation (continued)8.3 Repl
Page 19 and 20: Notes17

EQUIPMENT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?