2009 TRAINING - Cummins.com

G DRIVE
Midrange
NEW X1.3/2.5/3.3 UNITS
COURSES AVAILABLE THROUGH 2010
Heavy Duty
NH/NT855 QUALIFICATION
– 5 DAYS (2008-09Q)
COURSE OVERVIEW:
This Course includes an-depth study of the proven
product line covering the NH/NT855 Engine. Theory
and practical will focus on a full strip down and rebuild
of an NH/NT855 engine. The four main systems-
Lube, Cool, air and fuel- will be covered, along with
useful tips and hints for the service technician, as well
as some time being devoted to operation and
maintenance, troubleshooting.
WHO SHOULD ATTEND?
This course suits all technicians
with the skills required for the assembly and timing of
the new hardware features of the engine.
COURSE CONTENT:
• Introduction to the X family
• Fuel, lube, and coolant system
• Disassembly and assembly of engine
• Electrics and electronics
• Use of Insite and troubleshooting
• Written and practical assessment
High Horse Power
QSK19 CM850 MCRS QUALIFICATION
– 4 DAYS (2005-02Q)
COURSE OVERVIEW:
The participants will competently troubleshoot and
repair all engine systems on the new QSK19 CM850
engine.
WHO SHOULD ATTEND?
Technicians with a good knowledge of the QSK19
Engine and Basic Electrics.
G DRIVE
COURSE CONTENT:
• Engine familiarization and component location
• Engine parts and systems
• Engine strip and rebuild
• Basic faultfinding and troubleshooting
QSX15 TIER 3 QUALIFICATION
– 5 DAYS (2006-04Q)
COURSE OVERVIEW:
This Course will allow the participants to gain a level of
understanding whereby they will be able to identify
engine system components. To enable the participants
at the end of the training to show and describe the
components of the QSX electrical and mechanical
Systems.
WHO SHOULD ATTEND?
This course suits all technicians with some engine
knowledge.
COURSE OBJECTIVES:
Participants will be able to describe the four QSK19
CM850 engine systems. Identify QSK19 engine
components. Outline QSK19 Theory operation and
maintenance. Apply correct troubleshooting
procedures.
COURSE CONTENT:
• Engine Familiarization and Component location
• Fuel System MCRS.
• Operation and maintenance of QSK19.
• Trouble shooting and repair of the fuel system.
• Assemble & Disassemble of Injector and Fuel
Pump.
• Practical Fault finding..
• Trouble shooting, Engine Testing and repair of
engine faults using Insite.
• Written and Practical Assessment.
COURSE OBJECTIVES:
Upon completion of the Qualification the participants
will be able to apply new found knowledge and skills to
perform practical and written examinations to a skill
level set by Cummins Limited. During the Qualification
the participants will achieve competence in the use of
Insite in the troubleshooting of QSX problems together
22