SYGEF Product Catalogue

The peeling length l corresponds to the length of the
peeling blades.
For pipes of diameter d = 16 mm, chamfer about 2 mm
of the pipe end at an angle of 15 °. Prepare about 15 mm
of the pipe end with a scraper. Mark off the jointing
length of 13 mm on the pipe.
Thoroughly clean the fitting socket with absorbent paper
and cleaning fluid (e. g. Tangit cleaner). Use fresh paper
each time.
Mark the required position on both the pipe and the
fitting before jointing.
Fusion jointing procedure
Heating
Quickly push first the fitting onto the heating spigot to the
correct depth and then the pipe into the heating bush
axially, without twisting, and hold firmly. The heating
times in the table below are measured from this point on.
Fusion joints should not be used for pipes whose walls
are thinner than those listed in the table.
27