Circular Saw Blades
Untitled - LEUCO
Untitled - LEUCO
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Technical Information <strong>Circular</strong> <strong>Saw</strong> <strong>Blades</strong><br />
Tooth configuration<br />
The tooth design has a big influence on the edge quality and is depending on the following factors:<br />
Ι workpiece material<br />
Ι mode of application (with and across the grain)<br />
Ι direction of cut (along / across the grain)<br />
F Flat DA Inverted-v KO-WS Conical-alternate<br />
bevel<br />
F-FA<br />
Flat with chamfers<br />
on both sides<br />
DA-F Inverted-v + flat KO-HR-FAConical hollow back<br />
with chamfer<br />
F-WFA<br />
Flat with alternating<br />
chamfer<br />
DA-F-FA Inverted-v + flat<br />
with chamfer<br />
D<br />
Hollow-ground<br />
WS Alternate top bevel DA-D Inverted-v + hollowground<br />
D-FA<br />
Hollow-ground with<br />
two-sided chamfer<br />
WS-FA<br />
Alternate top bevel<br />
with chamfer<br />
DA-D-FA Inverted-v +<br />
hollow-ground with<br />
chamfer<br />
HR<br />
Hollow back<br />
TR Triple-chip ES Top bevel HR-FA Hollow back with<br />
chamfer<br />
TR-F Triple-chip + flat ES-L Top bevel, left G3 G3<br />
TR-F-FA<br />
Triple-chip + flat<br />
with chamfer<br />
ES-R Top bevel, right G5 G5<br />
TR-TR Triple-chip +<br />
triple-chip<br />
KO-F Conical-flat G6 G6<br />
Number of teeth<br />
The number of cutting edges subject to feed rate is to be found in section tool description on the respective pages. It is depending on the<br />
following criteria:<br />
Ι feed<br />
Ι RPM of the spindle<br />
Ι diameter of the circular saw blade<br />
Ι workpiece material<br />
Ι cutting quality (sizing cut / finish cut)<br />
Ι cutting height (single boards / stack)<br />
Ι stack height (no. of single boards)<br />
Ι pass<br />
1–69
Change language