Jade DSC: Site Readiness Instructions - Perkin Elmer Life and ...

More documents

Recommendations

Info

Rev. 2 4 Cryofill: LN2 cooling system requires 50 liters of liquid nitrogen to operate. It is the customer responsibility to make the LN2 available at the installation site of the Jade DSC. LN2 consumption is approximately 2.5 liters/hour and dependent on temperature range. NOTE: when handling LN2 wear appropriate safety gear as specified by your corporate safety officer or LN2 supplier f) Environmental Requirements: Laboratory Environment Temperature range 15 to 40°C Humidity
Rev. 2 • Chassis: Mini Tower (MT) • Factory Installed Operating System: Microsoft® Windows® XP Professional SP2 • Memory: 512 MB, Non-ECC 533 MHz, DDR2 1x512, Four DIMM slots • Hard Drive: 80GB SATA, 7200 RPM • Networking: Broadcom®, 10/100/1000, Ethernet Remote Wake Up and PXE Support • External I/O Ports: 8 USB 2.0 (2 front, 6 rear), 1 Ethernet (RJ45), 2 serial (9-pin) (16550 compatible), 1 parallel (25-hole, bidirectional), 1 VGA out • Expansion Slots: 2 PCI up to 4.2” H x 11” L, 1 PCIe x1 up to 4.2” H x 9” L, 1 PCIe x16 • CD-RW: 48x Max CD Rewriteable Drive • Video: Integrated video, Intel® GMA950 • Floppy Drive 3.5" 1.44MB diskette drive standard • Mouse: Dell USB 2-button optical mouse with scroll • Keyboard: Dell USB Keyboard (No Hot Keys) • Audio: Integrated ADI 1981 AC97 codec Software Requirements XP Professional/SP2 is required. i) Installation Overview: At receipt of the instrumentation, customer is to determine if any obvious shipping damage has occurred and is to notify the shipping company immediately. The customer is to unpack and verify the layout of Instruments and accessories with an eye to possible missing or damaged parts. You should unpack the instrument and accessories. The instrument should be placed on the bench along with associated components. Customer to hold Packing Material for CSE The Jade DSC is to be installed by a PKI Service Engineer, you should hold the instrument packing material for the Customer Service Engineer (CSE). Physical Installation (Instrument Only) The physical installation will vary based on system configuration. Physical Installation (Accessories) [As Required] Installation Test Standards A PKI Service Engineer will test the instrument in order to insure that its performance meets PerkinElmer’s manufacturing specifications. Reference materials are supplied with the instrument to test its functionality. Customer Orientation The customer must be available for an instrumentation orientation. j) Miscellaneous: If IQOQ validation is required for this instrument, please contact your local Service representative at 1800 762 4000. If additional purge gas splitter kits, filter driers or any additional spares supplies or accessories are needed please contact your local Service representative at 1800 762 4000. 5
Page 1 and 2: Rev. 2 Jade DSC: Site Readiness Ins
Page 3: Rev. 2 3 Regulator outlet pressure,

Jade DSC: Site Readiness Instructions - Perkin Elmer Life and ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?