Maxisafe-Product-Guide_Email
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GLOVE STANDARDS<br />
GENERAL REQUIREMENTS<br />
AS/NZS 2161.2:1998<br />
EN420<br />
The EN420 standard defines the general<br />
requirements for ergonomy, glove construction,<br />
high visibility, innocuousness, cleaning, comfort<br />
and efficiency, marking and information,<br />
applicable to all protective gloves.<br />
• Glove design and construction is suitable for<br />
its intended use.<br />
• Any seams present in construction do not<br />
result in a significant decrease in product<br />
performance.<br />
• The gloves will not harm the health or hygiene<br />
of the user.<br />
• Glove sizing conforms to set specifications<br />
with respect to hand circumference.<br />
• Minimum glove lengths are specified for each<br />
size.<br />
• Gloves must be generally marked with trade<br />
mark or other identification of<br />
manufacturer/representative, product code<br />
name or code and size.<br />
• Instructions for use.<br />
• Packaging carries additional information as to<br />
where the product can be obtained and<br />
pictograms denoting performance levels<br />
against Standards as appropriate.<br />
PROTECTION AGAINST<br />
MECHANICAL HAZARDS<br />
AS/NZS 2161.3:1998<br />
EN388<br />
The EN388 standard applies to all types of<br />
protective gloves with respect to mechanical<br />
aggression from abrasion, cutting, tearing and<br />
puncture. These ratings are calculated from<br />
laboratory test results and do not replace the<br />
actual testing of the product in real conditions in<br />
the field. The results also enable you to<br />
compare the performance between various<br />
products.<br />
• Level X: The test is not applicable, or the glove<br />
is not tested<br />
• Level 0: Nil performance or result<br />
• Level 1: Minimum result<br />
• Level 2: Good result<br />
• Level 3: Very Good result<br />
• Level 4 & over: Excellent result<br />
EN 388<br />
XXXX<br />
0 to 4: Tear Resistance<br />
0 to 5: Blade cut resistance<br />
0 to 4: Abrasion Resistance<br />
0 to 4: Puncture Resistance<br />
4 www.maxisafe.com.au