SIMOVERT MASTERDRIVES Vector Control - MEYLE - Meyer ...

More documents

Recommendations

Info

3 SIMOVERT MASTERDRIVES Vector Control Compact PLUS,Compact and Chassis Units General technical data Fig. 3/1 Compact PLUS units Fig. 3/2 Compact units Fig. 3/3 Chassis units 3/2 Siemens DA 65.10 · 2003/2004 Compact PLUS units Compact and chassis units
Compact PLUS units Compact and chassis units SIMOVERT MASTERDRIVES Vector Control Compact PLUS,Compact and Chassis Units Converters, inverters, AFE inverters, rectifier units, rectifier/regenerative units and braking units Cooling type Forced ventilation with integral fan Air-cooled Permissible ambient and cooling-medium temperature during operation 0 °C to +40 °C (reduction curves for +40 °C < T < +50 °C, see page 6/3) Water-cooled � Cooling water inlet temperature � Permissible ambient temperature during operation +5 °C to +38 °C 0°Cto+40°C Permissible ambient temperature during storage and transport –25 °C to +70 °C Installation altitude � 1000 m above sea level (100 % load capability) > 1000 m to 4000 m above sea level (for reduction curves, see Section 6) Humidity rating Relative humidity � 85 %, moisture condensation not permissible Climatic category Class 3K3 to EN 60 721-3-3 Environmental class Class 3C2 to EN 60 721-3-3 Insulation Pollution degree 2 to DIN VDE 0110-1 (HD 625. 1 S1: 1996), moisture condensation not permissible Overvoltage category Category III to DIN VDE 0110-1 (HD 625. 1 S1: 1996) Degree of protection To EN 60 529: Compact PLUS units: IP20; chassis units: IP00 (IP20 optional) Protection class Class I to EN 61 140 Shock protection To DIN VDE 0106 Part 100 and BGV A2 (previously VBG 4) Radio-interference suppression � Standard � Options To EMC product standard EN 61 800-3 for variable-speed drives No radio-interference suppression Class B1 or Class A1 to EN 61 800-3 Additional information The units are motor-side ground-fault protected, short-circuit proof and may be operated under no-load conditions. Paint finish For indoor installation Mechanical specifications � during operation � during transport Approvals according to UL/CSA 1 ) � Converters and inverters � Rectifier units and rectifier/regenerative units 2 ) � Braking units and braking load resistors 2 ) � Braking resistors for Compact PLUS units � dv/dt- and sinusoidal filter 2 ) � Radio-interference suppression filter type 6SE70 ... 2 ) � Line commutating and output reactors (iron) � 3NE1 series fuses are U 1) UL and CSA approval is not valid for units and system components 3 AC 660V–690Vand 890 V – 930 V DC. To EN 60 068-2-6 10 Hz to 58 Hz constant deflection 0.075 mm 58 Hz to 500 Hz constant acceleration 9.8 m/s 2 (1 g) 5 Hz to 9 Hz constant deflection 3.5 mm 9 Hz to 500 Hz constant acceleration 9.8 m/s 2 (1 g) UL File No. E 145 153 E 145 153 E 145 153 E 233 422 E 145 153 E 145 153 E 103 902 E 167 357 2) UL and CSA approval only in combination with SIMOVERT MASTERDRIVES converters or inverters. CSA File No. LR 21927 LR 21927 LR 21927 210040 (Certificate 1185101) LR 21927 LR 21927 General technical data Siemens DA 65.10 · 2003/2004 3/3 3
Page 1 and 2: vector control SIMOVERT MASTERDRIVE
Page 3 and 4: SIMOVERT MASTERDRIVES Vector Contro
Page 5 and 6: Vector Control Overview 1/2 Applica
Page 7 and 8: SIMOVERT MASTERDRIVES with water-co
Page 9 and 10: Compact PLUS/compact and chassis un
Page 13 and 14: Vector Control System Description S
Page 15 and 16: � The rectifier/regenerative unit
Page 17 and 18: Data is exchanged in accordance wit
Page 19 and 20: PMU operator control and parameteri
Page 21 and 22: The OP1S and the unit to be operate
Page 25 and 26: The engineering and process control
Page 27 and 28: Drive ES Basic � Drive ES is base
Page 29: Vector Control CompactPLUS, Compact
Page 35 and 36: Dimensions WxHxD SIMOVERT MASTERDRI
Page 37 and 38: Compact and chassis units Technical
Page 39 and 40: Cooling air requirement m 3 /s Comp
Page 47 and 48: Technical data Compact and chassis
Page 49 and 50: Maximum permissible operating press
Page 51 and 52: Maximum permissible operating press
Page 53 and 54: Technical data Compact and chassis
Page 57 and 58: Technical data SIMOVERT MASTERDRIVE
Page 59 and 60: Dimensions WxHxD Compact PLUS units
Page 65 and 66: Compact and chassis units Selection
Page 67 and 68: Technical data Compact PLUS units C
Page 71 and 72: Compact PLUS units Compact and chas
Page 73 and 74: Compact PLUS units Compact and chas
Page 75 and 76: Cable-protection fuses Duty class g
Page 77 and 78: Cable-protection fuses Duty class g
Page 79 and 80: Compact PLUS units Output filter re
Page 81 and 82:
Compact and chassis units Output fi
Page 83 and 84:
Compact and chassis units SIMOVERT
Page 85 and 86:
Compact and chassis units Contactor
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Switch disconnector 2 ) Rated curre
Page 93 and 94:
Precharging Resistor Rated value 1
Page 95 and 96:
Compact PLUS units Compact and chas
Page 97 and 98:
Commutating reactor 1 ) v D =4% Com
Page 99 and 100:
Compact and chassis units Cable-pro
Page 101 and 102:
Compact and chassis units Regenerat
Page 103 and 104:
Compact and chassis units Cable-pro
Page 105 and 106:
Compact and chassis units Regenerat
Page 107 and 108:
SIMOVERT MASTERDRIVES Vector Contro
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Bus adapter 1 ) Compact and chassis
Page 117 and 118:
Compact and chassis units SCB1 inte
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Vector Control 6SE71Converter Cabin
Page 125 and 126:
Cabinet units Cooling type Forced v
Page 127 and 128:
Technical data Cabinet units Rated
Page 129 and 130:
Cabinet units SIMOVERT MASTERDRIVES
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Technical data Cabinet units SIMOVE
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Supplementary order code Cabinet un
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Cabinet units Operator control pane
Page 161 and 162:
Cabinet units Line filters, line co
Page 163 and 164:
Cabinet units Additional control fu
Page 165 and 166:
Cabinet units Mechanical components
Page 167 and 168:
Cabinet units The options listed be
Page 169 and 170:
Vector Control Documentation and Tr
Page 171 and 172:
Page 173 and 174:
Cabinet units Standard documentatio
Page 175 and 176:
Compact PLUS/compact and chassis un
Page 177 and 178:
Vector Control Engineering Informat
Page 179 and 180:
� � � ��
Page 181 and 182:
Compact and chassis units Cabinet u
Page 183 and 184:
Quadratic load torque drives Drives
Page 185 and 186:
Single drives are frequency convert
Page 187 and 188:
For multi-motor drives, inverters a
Page 189 and 190:
The inverters for the individual dr
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Compact and chassis units AFE recti
Page 201 and 202:
Compact and chassis units Nominal p
Page 203 and 204:
Compact PLUS units Capacitor module
Page 205 and 206:
Block diagrams (continued) V/f char
Page 207 and 208:
Control performance For maximum per
Page 209 and 210:
Page 211 and 212:
Compact PLUS units Control terminal
Page 213 and 214:
Compact PLUS units Control terminal
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Application: SIMOVERT MASTERDRIVES
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Use of iron-core reactors � Drive
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
PROFIBUS DP If the PROFIBUS DP is u
Page 235 and 236:
CAN The CBC board (Communication Bo
Page 237 and 238:
SIMOLINK The SIMOLINK drive-interfa
Page 239 and 240:
With the EB1 (Expansion Board 1), i
Page 241 and 242:
With the EB2 (Expansion Board 2), t
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Vector Control Dimension Drawings 7
Page 265 and 266:
a Fig. 6 b Compact and chassis unit
Page 267 and 268:
1730 151,5 123,5 53,5 55 10 C/L+ D/
Page 269 and 270:
�� Fig. 17 Compact an
Page 271 and 272:
�� Fig
Page 273 and 274:
��
Page 275 and 276:
Fig. 31 Type Designation acc. to DI
Page 277 and 278:
PE M 6 PE PE M6 h h 2 h 1 340 325 3
Page 279 and 280:
e 2 ��
Page 281 and 282:
� Fig. 49 � � � � ��
Page 283 and 284:
��
Page 285 and 286:
� � Cabinet units 380 V to 480
Page 287 and 288:
��
Page 289 and 290:
Cabinet units 380 V to 480 V, 500 k
Page 291 and 292:
Page 293 and 294:
Cabinet units 500 V to 600 V, 1000
Page 295 and 296:
��
Page 297 and 298:
Cabinet units 380 V to 480 V (2 x),
Page 299 and 300:
Page 301 and 302:
��
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Page 309 and 310:
Page 311 and 312:
��
Page 313 and 314:
��
Page 315 and 316:
��
Page 317 and 318:
Page 319 and 320:
Vector Control Appendix A/2 Certifi
Page 321 and 322:
Page 323 and 324:
Page 325 and 326:
Page 327 and 328:
In the face of harsh competition yo
Page 329 and 330:
Page 331 and 332:
Automation & Drives Catalog Interac
show all

SIMOVERT MASTERDRIVES Vector Control - MEYLE - Meyer ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?