Compact Linear Actuator with Ball Screw Drive - Schaeffler Group

Accessories
Sensors For linear actuators MKUVS32, end position and
zero point sensors are available in various configurations,
see table Designation of sensors, page 20.
Typical end position sensors are designed as openers,
typical zero point sensors as closers, Figure 11,
and connection scheme, Figure 13, page 20.
The sensors contain Hall effect elements that detect a magnet
integrated in the side of the drive carriage.
For ease of mounting, the sensors are supplied with a 300 mm long
cable and an M8 3 pin industry standard connector.
In addition, a matching 5 metre long cable is available with a plug at
one end and bare cable ends at the other.
� End position sensor
� Zero point sensor
� M8 3 pin plug
� Connection cable
Figure 11
End position and zero point sensors
� LED
� Fixing screw
� Widened slot for sensor mounting,
on drive side only
Figure 12
Location of sensors
The individual sensors are located flush in a lateral slot in the
support rail, Figure 12. The sensors can be arranged at any point
over the entire length of the linear actuator and are fixed in place by
means of a set screw in the sensor head.
Schaeffler Group Industrial TPI 181 19
1
2
1
3
38
4
2
3
1
00014866
00014865