rental inspection procedure - Rossignol

FINAL INSPECTION
Complete the following inspection:
TOE PIECES
Check that the toe screws are firmly inserted.
Check that the release value indicators are present and
readable.
Check the re-centering of the toe piece.
• Hit the boot with a sharp blow at the boot toe.
• The boot must return powerfully to the skis center.
If this is not the case, check that the:
• Forward pressure is correct
• AFD is in good, clean condition
• Sole is clean
• Sole is not worn and complies with current ISO
standards
• Contamination on the boot sole. Clean the sole and
toe piece using warm water and soap
• Too much forward pressure. Readjust according to
instructions (refer to pages 12-13). For binding set
with a release setting in the lower half of the range,
the forward pressure can be adjusted slightly below
the mid point of the forward pressure scale.
• Contaminated or worn out AFD. Clean or replace
Teflon AFDs or lubricate the Glider by holding it off to
one side and applying grease/lube to the back side
of the Glider.
• Loose mounting screws in the toe.
• Contamination of the heel track. De-grease
with warm water and soap and relube using binding
grease.
22
HEEL PIECES
Check that the heel piece screws are firmly
inserted.
Check that the release value indicators are present and
readable.
Check that the brakes operate correctly.
REMEMBER
When customers pick up their equipment be sure to
discuss the eight points on page 26 of this manual. Also
have them read and sign the work ticket and give them
the instructions from the binding box.