rental inspection procedure - Rossignol

Recommendations

Info

COMP J SPEEDSET TEAM 4 QUICKSET ROXY SWEETHEART RENTAL 32
RENTAL Note: Rental and Speedset/Quickset products are considered rental products. If rental products are sold to a skier, you must supply customers with a copy of retail inbox instructions. RELEASE SETTINGS Toe Piece Adjust the release setting screw on the end of the toe piece. The release indicator is visible in the window located on the top of the toe piece. Release values must comply with QUIKSILVER ROSSIGNOL GROUP recommendations (Table pg 17) or to ASTM F-939 or ISO 8061. Heel Piece Set release values by the screw located at the rear of the heel piece. The release indicator can be seen in the the window located under the heel piece lever. Release values must comply with QUIKSILVER ROSSIGNOL GROUP recommendations (Table pg 17) or to ASTM F939 or ISO 8061. Dispatch Show the skier how to get in and out of the binding. Show the indicator value on the binding and the rental form. Have the skier read, sign and date the rental form and give them a copy. Discuss the risks of skiing including that ski/boot/ binding systems cannot prevent all injuries. 33 MAINTENANCE Rental equipment needs special care at the end of the season. Repairs have to be made and the equipment has to be prepared for storage. The main steps are: • Reduce all release settings to the minimum. • Close all heelpieces. • Check boot/binding connections and that there is no play in screws and components. • Check that brakes operate correctly. • Clean and lubricate the boot/binding interface and the Axitec, AFC or Teflon AFD’s. • Replace worn or damaged Axitec, AFC or Teflon AFD’s. • Dismantle the toe and heel sections on SPEEDSET/QUICKSET models (see page 24), and clean the tracks with a damp cloth. Re-lubricate with Rossignol grease and then reassemble. • Never clean bindings with solvents, hot water or a pressure wash. • Always store equipment in a dry place. • We recommend cleaning and lubricating binding at least two times per season.
Page 1 and 2: QUIKSILVER-ROSSIGNOL BINDING TECH M
Page 3 and 4: TECHNICAL TRAINING Completing the Q
Page 5 and 6: Look Z RV18 Z Race (all versions) P
Page 7 and 8: BINDINGS All ski bindings distribut
Page 9 and 10: MOUNTING USING TEMPLATES Using Temp
Page 11 and 12: Rossignol Integral and Look/Dynasta
Page 13 and 14: ROSSIGNOL WTPI 2 DYNASTAR EXCLUSIVE
Page 15 and 16: Rossignol Axium Junior Look-Dynasta
Page 17 and 18: I-BOX WC / I-BOX COMPOSITE PLATE BI
Page 19 and 20: Fitting the ski boot into the bindi
Page 21 and 22: INFORMATION FOR SKIERS REQUESTING D
Page 23 and 24: Note 1: For skiers 29lbs and under,
Page 25 and 26: RETAIL INSPECTION PROCEDURES We rec
Page 27 and 28: DISCRETIONARY SETTINGS If a skier h
Page 29 and 30: RENTAL/DEMO The rental department i
Page 31 and 32: Rossignol Comp J EPR Dynastar Team
Page 33: RENTAL BOOT-BINDING ADJUSTMENT Spee
Page 37 and 38: PRE-SEASON BINDING INSPECTION 1. Pe
Page 39 and 40: RENTAL INSPECTION PROCEDURE SAMPLE
Page 41 and 42: WARRANTY LIMITED WARRANTY Quiksilve
Page 43 and 44: 41 Warning/Liability Release & Agre
Page 45 and 46: THE QUIKSILVER-ROSSIGNOL GROUP 2007
Page 47 and 48: QUICK REFERENCES / NOTES Shop ID Pa

rental inspection procedure - Rossignol

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?