You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Password Enter<br />
DIAL-IN CONTROL<br />
You can control and check with your LS-30 from a phone anywhere in the world by enabling the auto-answer function (refer to (4-2) Set Telephone – Set Auto<br />
Answer) and set the ring count number.<br />
Notes: 1. If you connect a fax machine or auto-answering machine on the same telephone line, you might need refer to it’s manuals and Appendix A-7 to avoid any<br />
misoperation.<br />
2. The ring count number should be over three; otherwise, the noise on telephone line may trigger the dial-in control sequence.<br />
3. Any phone set with pulse dialing will not connect with or control the system.<br />
The operation of dial-in control is as follows:<br />
1. Dial the telephone number to which LS-30 is connected.<br />
2. After the preset ring count number, you will hear beeps.<br />
3. Key in the password (preceded by * and followed by # ) from the telephone keypad within 30 seconds. If the password is correct, you will hear beeps again,<br />
otherwise you should enter the password again.<br />
4. After entering the valid password, the LS-30 will enter monitoring mode for 60 seconds. During this time, you can enter commands from the telephone<br />
keypad to control the LS-30.<br />
* 0 : Disarm the LS-30 (echoed by beeps) after you exit Dial-in Control.<br />
* 1 : Arm the LS-30 in Home Mode (echoed by beeps) after you exit Dial-in Control.<br />
* 2 : Arm the LS-30 in Away Mode (echoed by beeps) after you exit Dial-in Control.<br />
* 4 : Check alarm event, hear voice message, or beeps if no alarm event.<br />
* 5 : 2-way speakerphone/monitoring only (echoed by beeps).<br />
* 6 x x 1 : Turn on the switch number x x (01-16).<br />
* 6 x x 0 : Turn off the switch number x x (01-16).<br />
* 7 1 : Turn on the Relay.<br />
* 7 0 : Turn off the Relay.<br />
* 9 : Disconnect the line immediately.<br />
Any other keys will extend the monitoring period for another 60 seconds (echoed by beeps).<br />
The Process of Dial-in Control<br />
Dial Phone Number Enter Password<br />
in 30 seconds 60 sec. monitoring<br />
Ring count as user set *xx--xx# Ready for key tone command<br />
18<br />
INSTALLER & CMS SETTINGS<br />
http://www.nettrading.ro/SCIENTECH/LS-30/MANUAL/LS-30%20manual050228.h...<br />
Page 22 of 42<br />
2009-12-18
Change language