LifeSOS - IceCom

Password Enter
24-Hour Zone YES/NO (default 24-Hour Zone NO): (For Burglar sensor)
24-Hour Zone/YES: This Burglar sensor’s alarm signal will be processed all the time regardless of the system operation mode, either in Arm
or Disarm.
24-Hour Zone/NO: This sensor’s alarm signal will only be processed in Arm Mode.
Home Mode Active/Inactive (PIR default Inactive, Magnet default Active): (For Burglar sensor)
Home Mode Active: This Burglar sensor will trigger alarm in Home Mode operation.
Home Mode Inactive: This Burglar sensor will not trigger alarm in Home Mode operation, only trigger in Away Mode operation.
Bell ON/OFF (default Bell OFF): (For Burglar sensor)
Bell ON: In Disarm Mode, the Base Unit will issue a doorbell chime when receiving a trigger signal from this sensor if the Bell status is set ON in Master
Mode (Refer to (3) Master Mode - Bell Check - Door Bell.)
Bell OFF: In Disarm Mode, doorbell chime will not sound when receiving a trigger signal from this sensor.
Suggestion: This state should be switched on for the Door Magnet sensors on the front and back doors.
Supervision ON/OFF: (Automatically set by the sensor itself)
(Refer to (4-1) Set Timer - Sensor Supervise Time.)
Supervision ON: System will check the “heartbeat” signal from this sensor.
Supervision OFF: System will not check the “heartbeat” signal from this sensor.
RF Voice ON/OFF: (Automatically set by the sensor itself)
2-way Radio ON/OFF: (Automatically set by the sensor itself)
Switch control: Select the switches that will be activated when this sensor is triggered.
X-10 Switch
As many as 16 X-10 switches (optional devices) can be controlled by each system. For setting on the X-10 devices, refer to the instructions with the
X-10 switch.
Note: For Remote Controller, if you press the DISARM button in DISARM Mode, the switches those have been assigned as active switches will
be turned ON or OFF.
30
http://www.nettrading.ro/SCIENTECH/LS-30/MANUAL/LS-30%20manual050228.h...
Page 34 of 42
2009-12-18