TLP100IRB2

MODEL : TLP100IRB2/
TLP100IRC2
Full License Plate
Camera
QUALITY PRODUCTS FOR THE PROFESSIONAL INSTALLER

MODEL : TLP100IRB2/
TLP100IRC2
Table of Contents
INTRODUCTION 3
Contents
DEVICE 4
QUICK START/INSTALLATION 5
Wiring

MODEL : TLP100IRB2/
TLP100IRC2
INTRODUCTION
Congratulations on your purchase of the Optix “Wide Angle Backup Camera”. With camera installed,
you are able to have a great visual of what is behind your vehicle while going in reverse. You also get parking
lines to guide you while backing up into a parking space, driveway, bays, etc.
Contents
1- License plate camera mount
1- AV Extension cable
1- Hardwire plug

MODEL : TLP100IRB2/
TLP100IRC2
DEVICE
TLP100IRB2/TLP100IRC2 OPTIONAL LOOPS
- License plate camera with frame GREEN LOOP
Uncut - Mirror Image
- Available in black and chrome Cut - Normal Image
- IR for low light areas WHITE LOOP
Uncut - No Parking Lines
Cut - Parking Lines

MODEL : TLP100IRB2/
TLP100IRC2
QUICK START/INSTALLATION
1. Before beginning the installation of the license plate mounted
camera, remove the existing license plate bolts and the license
plate.
2. Mount the license plate behind the camera frame and bolt
the license plate back on with the existing bolts. Be careful to
not over tighten and pinch the wires.
3. Route the wires to the inside of the vehicle and wire the camera.
Red wire to 12v reverse signal in vehicle and black to ground.
4. Once every connection has been made, adjust the camera to
the best and safest viewing angle.
OPTIONAL LOOPS
GREEN LOOP
Uncut - Mirror Image
Cut - Normal Image
WHITE LOOP
Uncut - No Parking Lines
Cut - Parking Lines
5. All wires should be routed under panels or carpet and
zip tied to existing harnesses for a cleaner factory look.
Accele Electronics will not be responsible for damages caused to your
vehicle due to improper installation. For complete owners manual
please visit https://accele.com/technical-support-ii/tlp100irb2 Thank
you for being a valued customer of ACCELE ELECTRONICS