Libretto uso e manutenzione Owner's manual Manuel d'utilisation et ...

E
General cleaning
To preserve the original shine on metal surfaces and
paintwork, wash and clean your motorcycle at regular
intervals depending on the type of use and according to the
particular road conditions. Use specific products, where
possible biodegradable. Avoid aggressive detergents or
solvents.
Important
Do not wash your motorcycle immediately after use,
as marks can form due to evaporation of the water on hot
surfaces.
Never clean the motorcycle using hot or high-pressure water
jets. The use of high-pressure washers may cause the seizure
and other problems with the forks and fork seals, wheel hubs,
electrical system, air intakes and exhaust silencers, and
consequently impair the safety of the motorcycle.
If parts of the engine are especially dirty or greasy, use a
degreasing agent, avoiding contact with transmission
components (chain, front and rear sprockets, etc.).
Rinse with warm water and dry all surfaces with
chamois leather.
62
Warning
There may be loss of braking efficiency immediately
after washing the motorcycle.
Never grease or lubricate the brake discs. This will cause
loss of braking efficiency.
Clean the discs with an oil-free solvent.
Warning
When cleading the seat, avoid rubbing it too hard
and the use of alcohol or other types of solvent; only use
water to clean the rear of the seat with the logo. The use
of cleaning agents other than water could cause
discoloration or removal of the paint.