helpline - Tommee Tippee Australia
helpline - Tommee Tippee Australia
helpline - Tommee Tippee Australia
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
10 6<br />
Setting up the Movement Sensor Pad (continued)<br />
• Switch HELPFUL on the ADVICE: sensor pad on/off switch (8), and check that the sensor pad is working<br />
by • touching Do not place the cot furniture mattress or other gently obstructions anywhere near on the where adaptor your cords baby and will be be sleeping. sure<br />
• Each to position touch should them produce so that nobody a flash can of the trip green over sensor them. light on the baby unit (6)<br />
together with an audible tick sound. The volume of the tick can be adjusted using the<br />
control • Keep on adaptor the baby cords unit away (9). from hot surfaces such as radiators and central heating<br />
pipes.<br />
• Test the alarm by continuing to touch the mattress for a few moments and then step<br />
away • The from adaptors the cot are and interchangeable stop all movement so can near be the used sensor on either pad. the baby unit or the<br />
parent unit docking station.<br />
• After approximately 20 seconds the alarm will sound and the red alarm light (7) will<br />
come<br />
• Always<br />
on. If<br />
position<br />
movement<br />
the<br />
is<br />
adaptor<br />
detected<br />
units<br />
again<br />
and<br />
after<br />
cords<br />
the<br />
well<br />
alarm<br />
out of<br />
has<br />
reach<br />
activated<br />
of your<br />
then<br />
baby<br />
the<br />
and<br />
red<br />
alarm<br />
any<br />
light<br />
young<br />
will<br />
children.<br />
flash to let<br />
Be<br />
you<br />
careful<br />
know<br />
not<br />
that<br />
to<br />
an<br />
position<br />
'event'<br />
the<br />
has<br />
adaptor<br />
occurred.<br />
where<br />
To<br />
a<br />
reset<br />
child<br />
the<br />
might<br />
alarm,<br />
switch<br />
try to<br />
the<br />
step<br />
unit<br />
on<br />
off<br />
it.<br />
and on again by closing and opening the lid (1)<br />
• Important: If the alarm does not sound after 20 seconds, check if something is causing<br />
movement • Never use or vibration <strong>Tommee</strong> around <strong>Tippee</strong> the monitor monitor. adaptors Then with test any the alarm other equipment. again. Nor<br />
should you use any other adaptors with your <strong>Tommee</strong> <strong>Tippee</strong> monitor.<br />
• Should the sensor pad become accidentally disconnected then the baby unit will go into<br />
alarm mode. Test this by disconnecting the sensor pad and checking that the alarm<br />
• Please note that the adaptors become warm in use - this is quite normal and not<br />
activates after approx 20 seconds.<br />
a hazard.<br />
HELPFUL • The adaptors ADVICE: convert your AC power to a safe low DC voltage.<br />
• A moving or swinging cord may be interpreted by the pad as a baby's movement.<br />
To avoid this, ensure that the cord is not positioned where it may be subject to<br />
movement.<br />
• You should ensure there is no vibration in or near the nursery, so that the sensor<br />
Setting up your monitor<br />
pad is monitoring only your baby's movements.<br />
• • You The should sensor always pad does insert not batteries carry any into electricity your Baby and unit will and not Parent affect your unit if baby even<br />
possible. Although your <strong>Tommee</strong> <strong>Tippee</strong> monitor will still work OK if powered<br />
if the mattress is subject to bedwetting or vomiting.<br />
by the adaptors and docking station alone the power will automatically be<br />
• switched Never immerse to the batteries the sensor in the pad event in liquid. of a mains To clean, failure. wipe with a dry, lint free cloth.<br />
• Never place the connecting cord amongst your baby's bedding, in contact with<br />
• Open the back casing of the baby and parent units using a screwdriver and insert<br />
4 any x AAA moving (LR03) objects, batteries or near in each. any heated surface.<br />
• • Take Always extra keep care connecting to ensure that cords the away batteries from your are inserted baby and correctly younger and children. the right way round.<br />
• Refit the back casing on both units.<br />
• Confirm the batteries are working by checking that the power lights illuminate on both<br />
units when switched on, (ensure that the mains adaptors are not connected).<br />
• If the batteries are low in either unit, the red power light will flash on that unit.<br />
• Battery power is disconnected automatically when mains adaptors are in use.