helpline - Tommee Tippee Australia

8
After setting up your monitor and before using it for the first time, and at regular
intervals thereafter, it is important to test that everything is working correctly.
Do this as follows:
• If your monitor has been in a cold environment (e.g. boot of a car), wait 30 minutes for
the electrical components to reach their optimum working temperature before using
your monitor.
Test the Baby Unit
HELPFUL ADVICE:
• The baby unit should be about 1 - 1.5 metres away from the baby's cot on a flat
surface.
• Never place the baby unit in the baby's cot.
• Make sure the unit and the adaptor cord are out of reach of your baby and other
young children.
Switch the unit on by lifting the lid (1).
• The red power light (2) will illuminate to indicate the unit is on. (If using batteries only, the
power light will flash if the batteries are low).
Ensure that the sensor mat on-off switch (8) is turned to the OFF position
Test the night light by pressing switch 4. (To conserve battery power the nightlight feature
will only be activated if the AC adaptors are being used).
Adjust the nightlight brightness control 5
HELPFUL ADVICE:
• Your Tommee Tippee monitor contains a unique nightlight with an integrated
dimmer switch.
• You may find it useful to use a lower brightness if you wish your baby not to
sleep in complete darkness and then adjust to a higher brightness for when
he needs attention during the night and you do not wish to turn on the main
bedroom lights.
helpline
If you are having any problems in setting up your monitor or
require any further information please contact our helpline on:
(AUS)1800 890 011 or (NZ)0800 877 876