SIEMOSYN Motors 1FU8 SINAMICS SIMOVERT MASTERDRIVES ...
SIEMOSYN Motors 1FU8 SINAMICS SIMOVERT MASTERDRIVES ...
SIEMOSYN Motors 1FU8 SINAMICS SIMOVERT MASTERDRIVES ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
09.03<br />
3.6 Shaft ends<br />
Table 3-3 Shaft ends<br />
Drive shaft end<br />
Diameter [mm]<br />
Thread [mm]<br />
7 to 10 DR M3<br />
above 10 to 13 DR M4<br />
above 13 to 16 DR M5<br />
above 16 to 21 DR M6<br />
above 21 to 24 DR M8<br />
above 24 to 30 DR M10<br />
above 30 to 38 DR M12<br />
above 38 to 50 DR M16<br />
above 50 to 85 DR M20<br />
above 85 to 130 DR M24<br />
Centering holes 60° acc. to DIN 332/Part 2.<br />
Second standard shaft end, code K16.<br />
© Siemens AG, 2003. All rights reserved<br />
<strong>SIEMOSYN</strong> <strong>Motors</strong>, <strong>1FU8</strong> (PFU) – 09.03 Edition<br />
Mechanical Design<br />
3.6 Shaft ends<br />
Up to frame size 160 L, for coupling out-drives, the second shaft end can transmit<br />
full the rated power.<br />
The full rated power is not applicable for <strong>1FU8</strong> motors, frame sizes 90 L to 132 M.<br />
In this case, only the rated power of the next smaller frame size can be transmitted.<br />
Please inquire for the maximum power which can be transmitted and the permissible<br />
cantilever force for belts, chains or toothed-wheel (gearwheel) out-drive for the<br />
second shaft end.<br />
A second shaft end cannot be provided if a separately-driven fan has been<br />
mounted to the motor. Please inquire for mounted brakes.<br />
Dimensions and tolerances for keyways and keys are in compliance with<br />
DIN EN 50347. The motors are always supplied with a key inserted in the shaft.<br />
<strong>1FU8</strong>/3-37
Change language