Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation
3.8 Wheel installing with a Shiver fork
For correct fork function, please follow the
instructions here below when installing the
wheel:
• Insert the wheel axle (A) through the right
wheel axle clamp, the wheel and the left
wheel axle clamp.
• Screw down the bolt (B) on the left side and
tighten to the required torque (see Table -
Tightening Torques).
A
• Fully compress the fork a few times to
properly align the fork legs.
English
• Tighten to the required torque (see Table -
Tightening Torques) the bolts (C) positioned
on both dropouts, with the sequence 1-2-1.
MZ001021
3
122
3.9 Fender installing
The Ø 32 mm legs forks and the 888 Series
forks can be equipped with an integrated fender.
The fender can be provided with the fork or
purchased separately.
When assembling the fender (F) you must insert
the small support bushing (H) between the
screw and the fender as shown in the picture,
and tighten the screws (G) with a 8 mm Allen
wrench to the required torque (see Table -
Tightening Torques).
6 mm
MZ001022
B
8 mm
5 mm
F
C
H
MZ001054
G
MZ001023
MZ009_1