You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance
4.4 Air Bleeding
2 mm
NOTE
This operation must be carried out with the fork
assembled on the bicycle and with the fork’s
legs fully extended (front wheel off the ground).
NOTE
The pressure generated by the air that can get
into the fork legs while the bike is being used
and which, due to the special shape of the oil
seals remains trapped inside, can cause the
fork to malfunction.
A
B
In case of malfunction or loss of legs’
smoothness please carry out following
operation on both legs:
• By means of a 2 mm Allen key, unscrew the
air bleed screw (A) located on the cap, in
order to drain the pressure generated inside
the fork’s leg.
• Check the oil seal (B) condition; replace if
needed.
• Tighten the air bleed screw (A) to the
recommended torque (see Table - Tightening
Torques), being careful not to damage the oil
seal (B).
MZ002013
MZ009_1
English
4
127
Change language