NL - Gebruiksaanwijzing - LaBina One

Using the pigmentation device for the first time
Turning on the device
Figure:
Back of the control unit
w Start the control unit by pressing the green On / Off key. The front panel lights
up.
w Turn off the control unit by pressing the greenOn / Off key again.
NOTE: Protect the pigmentation device from excessive
voltage Disconnect the control unit and mains adapter from the
power supply, when it is not needed.
Keys
Always start the handpiece with the needle
cartridge inserted to prevent damage to the
handpiece.
Speed keys
Start key
Start the handpiece
Pause key
Handpiece paused
Minus key
Reduce stroke speed
Plus key
Increase stroke speed
120
If the pigmentation device is not required for a long time, it is recommend that you
disconnect the control unit’s mains adapter from the power supply.
Display dimming in standby mode
To extend the display life and comply with the energy saving guidelines, the device
has a screen saver and an automatic
standby function.
The screen saver dims the screen after 10 minutes of no button being pressed
or handpiece being used. The automatic standby function takes effect after 60
minutes of no button being pressed or handpiece being used. To restart the control
unit, press the On / Off key on the back.
Date and time
11:06
04.05.2023
11:06
04.05.2023
LaBina ® One
w Pressing the Start key starts the selected handpiece and needle stroke. The
needle in the needle cartridge moves at the stroke speed shown on the display.
The Start key icon automatically changes to a pause icon.
w Pressing the Pause keystops the handpiece and the needle stops moving in the
needle cartridge. The Pause key icon changes back to the Start icon.
w The desired working speed can be set by pressing the Minus key and Plus key.
10