NL - Gebruiksaanwijzing - LaBina One

Using the pigmentation device for the first time
Setting up the control unit
Always place the control unit and the handpiece with the handpiece holder on a
secure, firm and level surface.
It must be guaranteed that the pigmentation device can always be operated
during use
.
NOTE: Protect the pigmentation device from being dropped
Damage may occur as a result of the control unit or handpiece
being dropped.
Connecting the AC adapter
Figure:
Back of the control unit
WARNING: Risk of short circuit and electric shock
Due to excessive mains voltage, faulty electrical installation or
improper handling.
Only connect the control unit to a properly installed power socket.
The mains voltage must always match the input mains voltage shown on the AC
adapter type plate!
Only connect the AC adapter to an easy to access power socket so you can
quickly disconnect the power supply in the event of a malfunction.
Do not use any damaged equipment or accessories. Damage to cables or the
equipment significantly increases the risk of electric shock.
Ensure that all plugs and cables are clean and dry. Never connect the pigmentation
device cables using damp hands.
Connecting the foot pedal (optional)
Connect the power supply for the control unit in the following order:
Plug the connector from the AC adapter power cable into the green power
connection socket on the back of the control unit.
Then plug the supplied AC adapter into the power socket (230 V).
CAUTION: Tripping hazard due to cables
People may stumble over loose cables and injure themselves.
Figure:
Back of the control unit
Plug the foot switch connector into the green foot pedal connection socket.
The handpiece is activated (turned on) by pressing the foot pedal. The handpiece
remains activated until the foot pedal is no longer pressed.
The connecting cables from the pigmentation device must be laid so that no one
can trip over them.
8