lecroy serial data analyzer operator's manual - TRS-RenTelco

ohms)
Clock /Data Output Rise/Fall Time 200 ps typical
Recovered CLK and DATA Jitter 0.015 UI rms typical
Recovered CLK and DATA Phase
Relationship
Source Channel 4 only
Data is centered on the rising edge of the clock
Trigger Sensitivity 1 division minimum and at least 10 mVp-p
Clock Recovery
custom filter settings
damping factor
natural frequency
Jitter Analysis
advanced (peak-peak, rms)
basic (Tj, Rj, Dj)
bathtub curve
conventional
cycle-cycle jitter
Dj breakdown
edge to edge (data to data)
edge to reference (data to clock)
effective
filtered jitter
Math Tools – Standard
number of poles
Standard PLL settings
(FC, Golden, PCIe, DVI, Custom)
half-period jitter
ISI plot
jitter histogram
jitter wizard
MJSQ
period jitter
periodic jitter (Pj) with peak frequency listing
synchronous N-cycle with bit pattern display
TIE clock jitter
TIE jitter
Display up to eight math function traces (F1 to F8). The easy-to-use graphical interface simplifies
setup of up to two operations on each function trace. Function traces can be chained together to
perform math-on-math.
absolute value
average (summed)
average (continuous)
derivative
deskew (resample)
difference ()
enhanced resolution (to 11 bits vertical)
invert (negate)
log (base e)
log (base 10)
product (x)
ratio (/)
reciprocal
rescale (with units)
30 SDA-OM-E Rev F